Technical/Restorations
Talk about restoring older speakers and other technical/electronic information here.
24280 topics in this forum
-
- 2 replies
- 170 views
-
- 16 replies
- 1.3k views
-
- 14 replies
- 410 views
-
- 1 reply
- 204 views
-
- 4 replies
- 577 views
-
- 1 reply
- 211 views
-
- 3 replies
- 329 views
-
- 3 replies
- 217 views
-
- 2 replies
- 169 views
-
- 8 replies
- 2.4k views
-
- 0 replies
- 630 views
-
- 0 replies
- 255 views
-
- 7 replies
- 199 views
-
- 3 replies
- 262 views
-
- 1 reply
- 430 views
-
- 1 reply
- 203 views
-
- 2 replies
- 161 views
-
- 1 reply
- 187 views
-
- 9 replies
- 204 views
-
- 1 reply
- 214 views
-
- 0 replies
- 200 views
-
- 5 replies
- 824 views
-
- 0 replies
- 218 views
-
- 0 replies
- 408 views
-
- 0 replies
- 408 views
-
Recent Posts
-
By Matt in LA · Posted
Here we are in April 2024 and my 2 1/2 year old Cinema 600 has dies, I presume with the same problem. I ordered the power supply. What are the names and size tamper proof screws on the back? I want to put in regualr screws because obviously these things need to be tampered with! - Thanks -
-
By SenorPwnador · Posted
Does anyone have a recommendation for paint for the squawker horns on these? Gotta replace the squawkers so I may as well remove the horns and paint them (they are peeling and need it pretty badly). -
By Woofers and Tweeters · Posted
The high road has less traffic allowing those who take it to go farther and faster. This thread will not get better, regardless of who said what. IMHO, I think it would be best to let this one fall off of page one and be gone in time or ask a Mod to nuke it. If you start a new thread, just be aware that: 1) There are some knowledgeable, helpful, and (most of the time) friendly members here 2) A lot of the members here know what something is worth (we have seen a lot) 3) We have more than what we need, so it's not easy to get a buyer here Sorry for your loss and GLWYS -
Welcome! You can find out all the info about them here: : If the crossovers haven't been tinkered with, the capacitor most likely need replacing. You can get approved caps from JEM Performance Audio: https://jemperformanceaudio.com/ I believe Dean is still repaing them if you want to send them off. @Deang -
this doesn't answer your question, but there's some good general info in the following: -
I know this is a bit of a large net to cast but I'm looking at a pair of La Scalas. I don't have the serial numbers yet but they were supposedly owned but the original owner for 50+ years. I'm assuming they might need some TLC (caps / crossovers / etc) but I was curious if there was anything that I should check / look out for? Any known issues to watch out for or avoid? Thank you in advance for your time and assistance. I'll edit the post as I get more info. -
By The History Kid · Posted
The short answer is yes. There's more to a sub than just the driver. I had an RSW-10 outperform a PSW PRO 660i - which is a 12" Polk subwoofer. The Polk wasn't a bad woofer, it just wasn't designed the same as the RSW-10, used a different cabinet acoustic method, better amp - just all around different. Even a move from the R-12SW to the RP-1200SW would be a major difference in sonic experience. -
The Ks sold? Finally? And the purchaser did not want these mid/tweet replacements? He/she will regret that decision IMHO.... -
-