Home Theater
Talk about Klipsch Home Theater products and setups including Floorstanders, Bookshelf Speakers, Soundbars and more here!
31646 topics in this forum
-
- 0 replies
- 93 views
-
- 3 replies
- 417 views
-
- 2 replies
- 230 views
-
- 207 replies
- 16.8k views
-
- 2 replies
- 253 views
-
- 3 replies
- 251 views
-
- 6 replies
- 575 views
-
- 1 reply
- 177 views
-
- 10 replies
- 380 views
-
- 11 replies
- 472 views
-
- 3 replies
- 157 views
-
- 49 replies
- 4.7k views
-
- 3 replies
- 503 views
-
- 6 replies
- 252 views
-
- 1 reply
- 277 views
-
- 2 replies
- 149 views
-
- 1 reply
- 84 views
-
- 9 replies
- 358 views
-
- 21 replies
- 418 views
-
- 1 reply
- 117 views
-
- 2 replies
- 200 views
-
- 18 replies
- 1.1k views
-
- 7 replies
- 343 views
-
- 17 replies
- 660 views
-
- 4 replies
- 245 views
-
Recent Posts
-
Not sure I could wait that long! -
More follow up, I just got off the phone with the folks at JEM performance. They still rebuild crossovers so I will send them mine and they can make sure everything is up to snuff. I can solder but this way they can inspect everything and replace / correct as needed. -
Great advice, everyone, thank you. Due to my total newbie status on the board I cannot "like" any more posts today.... however, please consider all advice "liked"!!
-
https://amp.tmz.com/2024/04/18/dickey-betts-allman-brothers-member-guitarist-dead-dies/
-
while you are in the woofer doghouse run a bead of glue along all seams and replace gasket material on the bottom piece of plywood, this insures a air tight seal of the doghouse -
-
Fixing the wow and flutter in the cassette players is a pretty big deal. Everything else was next. JJK -
By Dave MacKay · Posted
And lightly sand or DeOxit all the connections and connectors get new gaskets for the squawker inspect the wires from the network to the drivers and replace if dodgy -
At a minimum I was planning on running new speaker wires and connectors.
-
Oh, and also whenever I buy older Klipsch that have the network board like that, I always loosen and tighten every screw on it. This will help create a better contact path and remove years of oxidation.
-