Home Theater
Talk about Klipsch Home Theater products and setups including Floorstanders, Bookshelf Speakers, Soundbars and more here!
31646 topics in this forum
-
- 2 replies
- 251 views
-
- 4 replies
- 209 views
-
- 0 replies
- 320 views
-
- 3 replies
- 200 views
-
- 1 reply
- 192 views
-
- 3 replies
- 183 views
-
- 4 replies
- 211 views
-
- 3 replies
- 157 views
-
- 1 reply
- 169 views
-
- 12 replies
- 405 views
-
- 1 reply
- 240 views
-
- 0 replies
- 188 views
-
- 4 replies
- 178 views
-
- 0 replies
- 207 views
-
- 12 replies
- 271 views
-
- 5 replies
- 201 views
-
- 6 replies
- 213 views
-
- 1 reply
- 158 views
-
- 13 replies
- 487 views
-
- 14 replies
- 500 views
-
- 8 replies
- 235 views
-
- 2 replies
- 369 views
-
- 1 reply
- 184 views
-
- 1 reply
- 170 views
-
- 5 replies
- 198 views
-
Recent Posts
-
.thumb.jpg.4a109408ff171032876fbd99877bb1d9.jpg)
After my second BAR 48 died, Klipsch gave me a Cinema 600. It had just become available. Unfortunately, it only lasted a few months. I was then given a Cinema 800. Search these community forums for "Cinema 800" to learn more. Both the Cinema 800 & 1200 have reliability issues too but far fewer than the BAR 48 and the Cinema 600 do. Early firmware updates were a disaster but the latest ones are stable. You should be quite happy with your Cinema 800. I am. 🙂 -
-
-
developed some new single > bi wire speaker cables .....were sold to a hifi friend in scotland last week -
Does it drive all frequencies at equal SPL for a whole duration or just in spurts. I think duty cycle on a welder or air compressor? -
I would go as far as saying 2 of the same manufactures, with the same topology, etc. For example, Parasound HCA-750 versus Parasound HCA-1000.
-
Not sure I could wait that long! -
More follow up, I just got off the phone with the folks at JEM performance. They still rebuild crossovers so I will send them mine and they can make sure everything is up to snuff. I can solder but this way they can inspect everything and replace / correct as needed. -
Great advice, everyone, thank you. Due to my total newbie status on the board I cannot "like" any more posts today.... however, please consider all advice "liked"!!
-
https://amp.tmz.com/2024/04/18/dickey-betts-allman-brothers-member-guitarist-dead-dies/
-