Personal Music Systems
Talk about our KMC Music Systems, Portable Systems, Computer Speakers and legacy iPod speakers here.
5226 topics in this forum
-
- 1 reply
- 1.1k views
-
- 3 replies
- 977 views
-
- 5 replies
- 259 views
-
- 7 replies
- 3.9k views
-
- 1 reply
- 79 views
-
- 8 replies
- 9.5k views
-
- 18 replies
- 17.6k views
-
- 25 replies
- 52.8k views
-
- 5 replies
- 248 views
-
- 4 replies
- 185 views
-
- 1 reply
- 81 views
-
- 20 replies
- 18.7k views
-
- 11 replies
- 2.9k views
-
- 0 replies
- 164 views
-
- 7 replies
- 299 views
-
- 12 replies
- 1.2k views
-
- 3 replies
- 421 views
-
- 2 replies
- 381 views
-
- 24 replies
- 21.2k views
-
- 5 replies
- 713 views
-
- 10 replies
- 17k views
-
- 2 replies
- 189 views
-
- 3 replies
- 695 views
-
- 23 replies
- 2.2k views
-
- 3 replies
- 4.1k views
-
Recent Posts
-
Not sure I could wait that long! -
More follow up, I just got off the phone with the folks at JEM performance. They still rebuild crossovers so I will send them mine and they can make sure everything is up to snuff. I can solder but this way they can inspect everything and replace / correct as needed. -
Great advice, everyone, thank you. Due to my total newbie status on the board I cannot "like" any more posts today.... however, please consider all advice "liked"!!
-
https://amp.tmz.com/2024/04/18/dickey-betts-allman-brothers-member-guitarist-dead-dies/
-
while you are in the woofer doghouse run a bead of glue along all seams and replace gasket material on the bottom piece of plywood, this insures a air tight seal of the doghouse -
-
Fixing the wow and flutter in the cassette players is a pretty big deal. Everything else was next. JJK -
By Dave MacKay · Posted
And lightly sand or DeOxit all the connections and connectors get new gaskets for the squawker inspect the wires from the network to the drivers and replace if dodgy -
At a minimum I was planning on running new speaker wires and connectors.
-
Oh, and also whenever I buy older Klipsch that have the network board like that, I always loosen and tighten every screw on it. This will help create a better contact path and remove years of oxidation.
-