Klipsch Pro Audio
Talk about our Pro Audio and Cinema products here.
1226 topics in this forum
-
- 4 replies
- 395 views
-
- 3 replies
- 394 views
-
- 2 replies
- 393 views
-
- 5 replies
- 393 views
-
- 3 replies
- 392 views
-
- 0 replies
- 391 views
-
- 1 reply
- 391 views
-
- 6 replies
- 389 views
-
- 0 replies
- 389 views
-
- 12 replies
- 388 views
-
- 6 replies
- 387 views
-
- 0 replies
- 385 views
-
- 1 reply
- 385 views
-
- 1 reply
- 384 views
-
- 2 replies
- 384 views
-
- 6 replies
- 381 views
-
- 1 reply
- 379 views
-
- 1 reply
- 379 views
-
- 0 replies
- 378 views
-
- 2 replies
- 378 views
-
- 2 replies
- 378 views
-
- 0 replies
- 378 views
-
- 2 replies
- 375 views
-
- 3 replies
- 374 views
-
- 1 reply
- 374 views
-
Recent Posts
-
developed some new single > bi wire speaker cables .....were sold to a hifi friend in scotland last week -
Does it drive all frequencies at equal SPL for a whole duration or just in spurts. I think duty cycle on a welder or air compressor? -
I would go as far as saying 2 of the same manufactures, with the same topology, etc. For example, Parasound HCA-750 versus Parasound HCA-1000.
-
Not sure I could wait that long! -
More follow up, I just got off the phone with the folks at JEM performance. They still rebuild crossovers so I will send them mine and they can make sure everything is up to snuff. I can solder but this way they can inspect everything and replace / correct as needed. -
Great advice, everyone, thank you. Due to my total newbie status on the board I cannot "like" any more posts today.... however, please consider all advice "liked"!!
-
https://amp.tmz.com/2024/04/18/dickey-betts-allman-brothers-member-guitarist-dead-dies/
-
while you are in the woofer doghouse run a bead of glue along all seams and replace gasket material on the bottom piece of plywood, this insures a air tight seal of the doghouse -
-
Fixing the wow and flutter in the cassette players is a pretty big deal. Everything else was next. JJK
-