Klipsch News
Important news pertaining to Klipsch will be posted here.
Subforums
-
- 13.1k
- posts
160 topics in this forum
-
- 158 replies
- 71.9k views
-
- 458 replies
- 63.8k views
-
- 60 replies
- 22.4k views
-
- 31 replies
- 21.5k views
-
- 56 replies
- 21.4k views
-
- 59 replies
- 16.3k views
-
- 64 replies
- 15.3k views
-
- 41 replies
- 15k views
-
- 37 replies
- 13k views
-
- 42 replies
- 12.9k views
-
- 17 replies
- 12.8k views
-
- 63 replies
- 12k views
-
- 40 replies
- 11.9k views
-
- 13 replies
- 10.9k views
-
- 20 replies
- 9.9k views
-
- 15 replies
- 9.6k views
-
- 26 replies
- 9.4k views
-
- 2 replies
- 9k views
-
- 12 replies
- 9k views
-
- 11 replies
- 8.7k views
-
- 32 replies
- 8.2k views
-
- 11 replies
- 7.7k views
-
- 45 replies
- 7.5k views
-
- 18 replies
- 7.3k views
-
- 17 replies
- 7k views
-
Recent Posts
-
Not sure I could wait that long! -
More follow up, I just got off the phone with the folks at JEM performance. They still rebuild crossovers so I will send them mine and they can make sure everything is up to snuff. I can solder but this way they can inspect everything and replace / correct as needed. -
Great advice, everyone, thank you. Due to my total newbie status on the board I cannot "like" any more posts today.... however, please consider all advice "liked"!!
-
https://amp.tmz.com/2024/04/18/dickey-betts-allman-brothers-member-guitarist-dead-dies/
-
while you are in the woofer doghouse run a bead of glue along all seams and replace gasket material on the bottom piece of plywood, this insures a air tight seal of the doghouse -
-
Fixing the wow and flutter in the cassette players is a pretty big deal. Everything else was next. JJK -
By Dave MacKay · Posted
And lightly sand or DeOxit all the connections and connectors get new gaskets for the squawker inspect the wires from the network to the drivers and replace if dodgy -
At a minimum I was planning on running new speaker wires and connectors.
-
Oh, and also whenever I buy older Klipsch that have the network board like that, I always loosen and tighten every screw on it. This will help create a better contact path and remove years of oxidation.
-