Jump to content

scriven

Regulars
  • Posts

    615
  • Joined

  • Last visited

Profile Information

  • Gender
    Male
  • Location
    South Elgin, IL

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

scriven's Achievements

Forum Veteran

Forum Veteran (4/9)

0

Reputation

  1. And I thought I had no taste when it comes to colors! []
  2. I dont understand the series/parallel bit in the diagrams above. It looks to me like both are parallel. The one labeled series just has the polarity reversed on one of the drivers. What am I missing? (Hay Doc, how about that for a straight line!)
  3. I will certainly yield to your experience. Thanks for the correction. It seemed to me that most of them that I have measured were closer to 6 ohm but I don't go around measuring the DCR on woofers very often.
  4. You are measuring DC resistance not impedance. The impedance will vary with signal frequency and can't be measured with a DMM. 4.8 DCR sounds a little low for an 8 ohm woofer but not totally out of line. Your right about the rated impedance being a "nominal" figure.
  5. One of those $1500 Corns would make a great center for thishttp://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=5802793987'> pair of "C" style Khorns - only $3237!
  6. Michael, I think you just invented bi-speakering!
  7. I agree. Sniping is the only way to go. A bunch of folks are two stupid to read the rules of the game and figure out a decent strategy to play it!
  8. Hard to tell from the picks. That does look like a KSW sub next to one of them.
  9. Don't worry Dean, you have all the balls! BTW - I like your sig.
  10. You might want to make a steeper slope, just to be sure! [] Actually, you should probably set it up so the squawker and tweeter are aimed at your ears. BTW - Welcome to the forum!
  11. The factory risers are designed to be screwed into the bottom of the speaker.
  12. Hit the "quote" button in the post you want to reply to. Click on the quote button just to the right of reply.
×
×
  • Create New...