lumi38ca

I am thinking of adding a second sub to my current system. I have one KSW-10 my question is, would I need to match the current KSW 10 with the same or can I go with any Klipsch sub, or other make for that matter? Thanks

So may not make sense to install an additional set of speakers in the rear to get more sound? Thanks

I currently have the synergy line F2 in front S2 surround and C2 Centre. I have a fairly large room and noticed not too much sound comming from the S2 surrund (even after adjusting through my Denon receiver) which are about half way in my room and slightly behind the seating area. I'm looking to add some more sound in the rears directly behind the eating area which about 8 feet away from the S2 surround the attached picture will give you some idea I was thinking of going with a pair of B2 bookshelf speakers. Appreciate some feedback Thanks Paul

Thanks Again to all.

I'm up and running with sound once I went throughtthe auto set-up again, with exception of the sub as I need to pick up a cable for it. Just to be clear I can use a coaxial single cable going from the sub to the receiver (red) how about the white...Assume the shop I pick it up can help

Thanks All, will advise once I geet a chance today

One more questons on the Sub hook up using the Pre-Out, what type of cable is used for this. Thanks

Thanks for the info. will keep my eyes open

i'm thinking it's the set up, as the test button emitts a fuzzy noise frm each speaker indicating the hook up is fine. I'll try the set up Thanks for the response

Thanks, this is what I tried initially but no sound...I'm wondering if it is something I need to do on the receiver set up? I will take a look

Thanks, appreciate the help....i'm anxious to start hearing some sound

I hooked up my new speakers to my Denon 1907 receiver and no sound. don't htink I did it properly There are two positive and two negative on each speaker (Top & Bottom) on the front speakers and one Postive and one negative on the rear SS. On the receiver there are A & B posts...can someone help me on how to hook these up Same with the SS1 I have, assume they go on the rear not the zone 2? Also, I have a 10" Sub but not sure how to hook this up as well. Thanks

Thanks very much, this will help!

Thanks for the advice. One other question since I am a newbie. How do I wire my speakers, not familiar with these screw type plugs and not sure if I need to wrap the sire around the threads and tighten or pass the exposed wire through the holes then tighten. Paul

Need some help. I recnetly purchased F2's, sub10 and SS1 and need to match the centre speaker. I live in Canada and BB only carries the C1 but understand I need a C2 to match. Any suggestions on where to find a C2 or waht my alternatives are whether Klipsch or other brands Thanks