biglaz

Yes. If it does not register any impedence or makes no sound usually means the diaphram is burnt out.

What ever amp you get you need to have a filter to limit low frequency to the reflex subs at the frequency the cabinet unloads the driver, probably around 35 or 40Hz. Also, I always suggest getting all the power you can get. Low frequencies suck power. Hope this helps.

Are the crossovers mounted on the back of the terminal board?

djk, thanks.

When you say add a 15ohm resistor in parallel with the mid, does that mean in the + line or in the - line? I am a crossover dummy. I put a 16 ohm resistor across the mid terminals and I am using tap 1 for the mid and tap 2 for the tweeter. So do I have the resistor attached wrong? Thanks to you and Moray for your help

I just recently obtained a set of Heresy w/K53 driver and k 701 horn and type E crossover. What are the factory settings on the autoformer and can they be changed for different output level for the mid and tweeter?

Thank you.

Is there any type of cabinet lining in the Hersey I and how much for example; R13 insulation lining the walls or stuffed. Thanks, biglaz

Thanks for the tip.

I am building new cabinets for a pair of heresy I speakers. Does anyone have any tips on how to get the drivers mounted on the back side of the baffle ie; get the centered etc. Thanks,

Thanks to both responders. You have helped me a great deal.[]

Are there any signifigant differences between these drivers. I have 1 of each and would like to use these in a heresy project. Or should I hold out and try to get 2 of the same?[*-)]

Are the JBL 2042H drivers 18" subs?

Is $150.00 for a pair of speakers and cabinets? Would you be interested in selling just the drivers and shipping to 40160?

Very nice looking table. Thanks I will consider this however, it is a little over my price range.