Jump to content
The Klipsch Audio Community

jason str

  • Content Count

  • Joined

  • Last visited

  • Days Won


Everything posted by jason str

  1. Terrible news Bruce, so sorry. Travel safely.
  2. Many of my plans are older from when i was one of the BFM authorized builders witch plans have probably been updated to include MDF. I just avoid it personally as the only advantage is that its a bit smoother surface for veneering.
  3. MDF is not recommended. Can't stand the stuff myself either.
  4. Or big bag of weed for a pillow, one of the best sound upgrades available.
  5. The only advantage to using Baltic Birch is its less prone to damage than softer materials such as moving them around often for pro sound use. I suggest on the next build you consider using Auraco plywood and building the cabinet as wide as possible to get as much as you can out of the designs. Your build looks nice by the way and I'm sure after building this first one you realize the design is so well thought out you really don't need to spend as much on material or drivers to get dam good performance out of them.
  6. Ported subs will have a steeper roll off than sealed models. Ported horns included.
  7. Sealed subs work better in small rooms because they take advantage of cabin gain to fill in the lower octave. Cinema's or movie theaters are too large to take advantage of any cabin gain thus making them a poor choice.
  8. Play a 30 Hz test tone through the mains and it will give you your answer.
  9. Any Air leak will impede woofer performance.
  10. Make sure there is nothing blocking the gasket from sealing like sawdust from one of the screw holes ETC... For the gasket to work you need smooth surfaces on both sides, that or something is warped or damaged on the mating surfaces. You may be able to get by using a thicker gasket to compensate for that.
  11. There should be no air leaks. Is the gasket compromised ?
  12. 3/4" Plywood is never actually 3/4" thick, its much closer to 18 mm. Stay away from the Chinese stuff.
  13. Any soft rubber feet will do, if the floor is uneven use 3 in a triangular pattern to assure a wobble free footing.
  14. Makes sense to use up scrap material where you can, i used mine for bracing normally.
  15. You can also try asking for assistance on the Mini DSP forum.
  16. Rotten off speaker grille on the Toyota ?
  17. $23.00 should buy you a Klipsch badge. Look for the Klipsch ProMedia 2.1
  18. He will know if it was abused from over excursion, the high pass filter should be used to protect your investment.
  19. The risers were very likely part of the cut sheet for matching purposes, check the bottom of the risers.
  20. You could easily get by using the 12" driver version for that setup, the 15" driver version would be total overkill.
  21. Could very well be the earlier Chorus used plywood in the construction as mentioned. The cabinet material description implied by Klipsch says MDF but it seems this must be taken with a grain of salt. Information on Chorus and k-48.pdf
  22. Horn loaded subs put out clean effortless bass, its worth the extra effort if this is the goal. The THTLP just stands on end firing up into the ceiling using minimum floor space. What kind of system components are you using ?
  23. Post a picture for the OP, i have no doubt Klipsch used scraps available at the time so not to waste good stock. My point was not to expect plywood where MDF was specified.
  • Create New...