Could sound better

CCR run thru the jungle

Mine is "feels so good" by Chuck Mangione.

In your case I believe CCR shares in responsibility.

I had some good times during my 36 month rotation there. Got a piece of the Berlin Wall put away somewhere.

I got hooked on Klipsch while stationed in Stuttgart in 1988. Heresy's played thru a Carver c-1 preamp & m-1.0t amp.

I would like to send her something A little more substantial than a The One speaker but she’s in an apartment and I’m worried about the neighbors. Maybe earplugs and Margaritas will work if I send her my back up system.

I listen to the music, I think. My Cornwall’s sound nice, but my ESS with heils sound good too, albeit different. So I’m not sure if it’s the equipment or the music?

I meant the wire, everybody knows when doing electrical work you only use one hand.

Aloha!!

We’re you holding it with both hands?

I’ll check Amazon

I believe it’s 110v in Oahu

Wouldn’t the preamp tubes have more effect on the final sound than the power tubes?

Hello to all, is it possible to purchase a Klipsch The One ll for a PHD student all by herself in a far away land on this forum. She just arrived at her year long intern location and I would like to send her something to play music on. thanks in advance. fyi: she’ll be treating veterans.

Thanks to all for contributing to this endeavor. i’ll consider all before I decide on a course to follow. thanks Jeff!! Cheers!!

Backfire, I have tried them out thru a CD player and a turntable. The sound isn’t too bad, rather nice but veiled. Almost like a a curtain in front of the speakers. Gonna recap, iec, & fuse for now. thanks!!

The photo is from another amp I have but the VOM has a similar tonal circuitry

Maynard, thanks for the input. If I left the tonal controls could I create a tonal circuit with new caps & resistors following a schematic of the tonal pack like the in the attached photo?

Mr. Medwin, Your suggestions are appreciated. I am by no means an expert at this kind of thing but my soldering skills are ok. These 2 amps are in very good condition so your recommendation is understood. My CD player does not have a volume control. I was planning on procuring a tube preamp with no tone controls so I would ultimately get stereo sound instead of mono and use the amps tone controls. i may reach out to you in the future regarding this project. I assume Mr. Percy is a member of this forum? Thanks.

I have 2 of these mono tube amps that I would like to recap and incorporate into a 2 channel system. My question is: these amps only have a phono input. Do I need to alter the wiring to make them play thru a CD player? thanks.

Set the bias after the amp is warmed up. It's small increments, remember that any adjustment on one side will affect the other side. Dude ditch the 5963's and try a balanced Voice of Music branded 12au7 in the center position,Trust me. Outer preamp tubes need to be well balanced and matched.

We were lucky to see them in Los Angeles 2 years ago, great show. The bass player is awesome.

https://m.youtube.com/watch?v=Qq7X_vEd_jU

The sonic gods are smiling on me!! Setting the phase to 0 did the trick!! thank you sir!!

Ok, I’ve done that but same level on preamp music sounds smeared. I run Cornwall ll’s Thanks.