Jump to content

raeggis

Regulars
  • Posts

    100
  • Joined

  • Last visited

Everything posted by raeggis

  1. Useful old thread. It is clear that the bass response specifications have been changed by mistake since the first speakers were produced.
  2. I have new caps, same value as originale, only plug and play ๐Ÿ˜€ no measurements. Bass plays Nice up to 600 hz, same db on mid horn. So cross over is ok. Vokals is fuller. with Faital vs K48.
  3. I tuned passive radiator around 32 hz. A few hz lower than Faitals 35 hz Fs . The deep bass is lissenable to under 30hz. Som i have a +2 db at 26 hz, and -2 db on the rest under 26hz on the equalizer. But the deep bass is good on flat eq too. I did a massage on bass speaker AS IT vill take a long time to play it in , before membran loosenes up. Fatal did not favorisise any frequenzy at all. K48 did that at 40 hz.
  4. I want to test out xindak a600e on my Chorus II speakers
  5. Interesting speakers ๐Ÿ‘๐Ÿผ
  6. LaScala would be better with another bass drivers with lower fs. and some help from a equalizer. Remember to cut bass frequenzy that goes lower than the drivers can make . Examle cut 20 hz 25hz 31hz 35hz to zero ๐Ÿ‘
  7. Back side on Klipsch Chorus II with Faital pro driver.
  8. Nice result of the work after some black painting on grinded areas๐Ÿ˜‰
  9. Testing Faital driver in bigger hole ๐Ÿ‘it fit well
  10. Here is the tool, and hole is allmust ready
  11. Here some marking to new size๐Ÿ˜
  12. This hole is a little to small for a Faital driver
  13. Faital with Neodymium Slug magnet and K48 with ferrite magnet
  14. I will try to finish both speakers in a few days with new Faital bass drivers.
×
×
  • Create New...