Jump to content
The Klipsch Audio Community

SiliconTi

Regulars
  • Content Count

    227
  • Joined

  • Last visited

Community Reputation

63 Excellent

About SiliconTi

  • Rank
    Forum Veteran

Profile Information

  • Location
    New Hampshire, USA

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. OK, Cornwalls here. They are v1 cabs with v2 drivers (original, not modified). Klipsch did this before the v2s came out for a year or so. Consecutive serial numbers. Functionally they are a 10/10. Cabs are a 9/10. Cane grilles, oiled walnut cabs. I am at least the third to own these. They were rough when I received them. I washed the grilles (about 10 times) to get the dirt and nicotine out (no, they do not smell) and redid the cabs redoing the veneer (all front edges were redone, other small patches filled in, see picts), sanding them bare and reoiling (no stain). Grilles had screws in them at some point. I put screws back in to cover the holes using brass screws so they do not stand out. Correct badges are there on both. They sound great! No, I'll not ship them. Pickup in 03852. Asking $1000 or best offer Let me know if you have any questions. Thanks for looking!
  2. Nice. I have the QS Line Pre-amp and really like it.
  3. I actually have experimented with setting my Cornwalls and La Scalas at 45 degrees - right in a corner. I like it very much this way as it tends to even out the channels and reduce the mids of the LS quite a bit. I read a white paper on it and decided to give it a try.
  4. Umm, OK, Ok... I think the main point of the OP is that the speakers should come first. I agree with that statement.
  5. SiliconTi

    Mesmerising

    Very interesting.
  6. I really want a set of Belles, but that water damage is scaring me off...
  7. Well, mine is a Boston PV-400 I bought in 2001 and it is still going strong.
  8. The AR-2 series has a complicated history. If they are labelled AR-2xa, I would say that they were originally AR-2x that were upgraded to ax standards via the factory kit. For the whole scoop, see here: http://www.classicspeakerpages.net/IP.Board/index.php?/topic/5003-ar-2a-vs-ar-2ax-also-ar-2-series-history/
  9. Well, if the driver is installed over the padding (rather than being attached to the back of the motor board), it should be OK. I'd keep the padding shallow too.
  10. I (and my wife) are so glad you are not closer. I have LS, but the Belles are just sooooo pretty.
  11. I could be wrong, but this reeks of being faked.
  12. YAY! It's mine! HA HA HA! Thanks, it is better than advertised with super fast shipping. Thanks for helping me finish this project off!
  13. Special Thanks to @analogman - he had just what I needed to make this project a success. Thanks!
×
×
  • Create New...