Kamidioblitz

Good to hear the RF7 make you happy. I’m considering the RF7 iii myself. If you go down the MINI DSP route, I strongly advice to get the HD variant. This gives you the opportunity to create a steeper curve at your low frequency cutoff point. I use two R115SW in my room and have a low frequency and 20hz as cut off point because they are designed to output as low as 18 hz. Trying to let them output below 18hz only generates port noise. Verzonden vanaf mijn iPhone met Tapatalk

I would also opt for a Mini DSP 2x4 HD. Integrating 4 subs while using a Mini DSP has a steep learning curve. There are lots of YouTube videos on the subject. I would use the videos of home theater guru or home theater gamer. You would also need a to buy Umik 1 and install REW software. REW is free and gives you the tools to measure the subs and asbest them individually both also create a house curve. Verzonden vanaf mijn iPhone met Tapatalk

My first suggestion would be to get a sub. This allows you to use a crossover on your fronts and redirect the low frequency’s to your sub. This results in more headroom for your amp and thus more power for your speakers. Verzonden vanaf mijn iPhone met Tapatalk

Double

Added extra height speakers and configured them as top middle Atmos speakers. After adding those extra channels and the Panasonic ub9000 I’m finally finished! The top middle Atmos speakers fill the gap between the front and rear height channels. Although not 100% according to the spec this sounds terrific. Verzonden vanaf mijn iPhone met Tapatalk

Added extra height speakers and configured them as top middle Atmos speakers. After adding those extra channels and the Panasonic ub9000 I’m finally finished! The top middle Atmos speakers fill the gap between the front and rear height channels. Although not 100% according to the spec this sounds terrific. Verzonden vanaf mijn iPhone met Tapatalk

Double

Added extra height speakers and configured them as top middle Atmos speakers. After adding those extra channels and the Panasonic ub9000 I’m finally finished! The top middle Atmos speakers fill the gap between the front and rear height channels. Although not 100% according to the spec this sounds terrific. Verzonden vanaf mijn iPhone met Tapatalk

I cross my entire setup at 100hz. The overall balance just sounds better in my setup. Running dual Klipsch R115 and RF82MK2 mains. The subs are controlled using a mini dsp 2x4hd. Verzonden vanaf mijn iPhone met Tapatalk

And an extra set RB51 to be used as top middle Atmos. Verzonden vanaf mijn iPhone met Tapatalk

Double post

Impressive setup!!! Verzonden vanaf mijn iPhone met Tapatalk

Impressive setup!!! Verzonden vanaf mijn iPhone met Tapatalk

Hegel H90 can be had for around 1200 euros new. Nice DAC and plenty of power? Verzonden vanaf mijn iPhone met Tapatalk

Currently have: RF82MK2 RC62 RB61 (rear surrounds) RS62 (side surrounds) RB51 (front and rear height) Dual R115SW Have owned RF25 RC35 RS25 KSW-10 Verzonden vanaf mijn iPhone met Tapatalk