OutLier4L

“Level/Gain: Essentially, just a volume knob. You can control the subwoofer's volume directly here. Or, you can simply set the knob to about 60-75% (about 2 or 3 o'clock) and then control the subwoofer volume within your receiver or pre-amp settings.” Never mind, didn’t realize in the manual that Level was basically Gain.

I wondered about that Auto On, I’ll switch it on or off like you said when I’m not using it. As far as cleaning, i could try that but its brand new; I would hope its not dirty already One more thing, the manual covered everything except Gain. Got a general rule of thumb for that? thanks for your response

hi my sub is an R-100SW which is connected to my R-15PM’s using LFE, the Gain is about 3/4, the Low Pass is set to LFE. This setup is primarily used for with my turntable AT-LP60X connected via 3.5mm/RCA cable, i use the Phono setting. Auto On is on and Phase is 0 ok so here’s the question. when i’m down using them I turn the speakers off but every five minutes or so you can hear the sub make a sound, its the sound it would make when you turn it on I guess is the only way to explain it. it’s faint but noticeable. based off the details provided above, is there something i should be doing different?