EcuaJoka
-
Posts
6 -
Joined
-
Last visited
EcuaJoka's Achievements
Newbie (1/9)
0
Reputation
-
I’m just going to bi wire them with 4 to 2 banana cables, and call it a day. And hopefully in the fall get a power amp. thanks.
-
I had it setup with audyssey and the h2’s were assigned to the LF ports from the speaker. With no pins. So if it’s unnecessary, then these speakers just have an extra set of ports in case needed. So in conclusion, I just need to connect the height speakers and the HF ports from the speaker, to my receiver and leave LF ports on the speakers alone? at this rate, I’m getting a sound bar 😂😭😭
-
I was able to connect the speakers this way. It’s it correct? speaker / Receiver Atmos - height 1 L&R HF to front L&R LF to height2 L&R Can I use the k4B-2B Bi-Wire Speaker Cable? Which is the 4 banana plug to 2 banana cable. I may have misplaced the pins.
-
I was able to connect the speakers this way. It’s it correct? speaker / Receiver Atmos - height 1 L&R HF to front L&R LF to height2 L&R
-
I figured it out.... I will let you know
-
EcuaJoka joined the community
-
I also received these speakers, but as a gift. So would i need a Bi amp cable? The cable that has 2 banana connections on one end, and 4 banana connections on the other end. I have a Marantz 6013 as my amp. Thanks. Steve