Jump to content

Search the Community

Showing results for tags 'bi-wire'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


  • Klipsch Announcements
    • Klipsch News
    • Klipsch Pilgrimage 2020
    • Klipsch Website & Forum Info
  • Klipsch Museum of Audio History
    • Klipsch Museum: News & Announcements
    • Ask the Historian
    • Klipsch Museum: General Discussion
  • Klipsch Audio
    • General Klipsch Info
    • 2-Channel Home Audio
    • Home Theater
    • Subwoofers
    • Architectural
    • Klipsch Pro Audio
    • Technical/Restorations
    • Headphones
    • Personal Music Systems
    • Talkin' Tubes
    • Solid State
  • The Klipsch Joint
    • Garage Sale
    • Lounge


There are no results to display.

Find results in...

Find results that contain...

Date Created

  • Start


Last Updated

  • Start


Filter by number of...


  • Start





My System

See My System

Website URL








Found 3 results

  1. I have started making a home audio set up i have already set up 2 r51m bookshelves a 404c a sub and the set of dolby atoms 500sa on the way Looking to purchase 2 rp 6000f's but I don't want to bi amp because I would have I sacrifice 2 chanels can I bi wire these speakers for left and right on the sony str-dh790 i already looked in specs and contacted customer service with no answers Is it even worth it to bi-wire these speakers if this receiver accepts it
  2. Tommy39


    Hi, I am new to the setup of my home theatre system. I have an AV receiver Yamaha A1060, RF260 floor standing speakers, RP250C, R14-S surround, R-10SW. I was so careless that I didn't remove the jumpers when doing a bi-wire. While doing the YPAO with a mic on the Yamaha, the AV receiver shuts down when it was half way doing the calibration. I didn't realised it was the jumpers, the receiver was showing "Check SP wire". I did the YPAO a few times (The receiver shut down a few times). I just wanna to ask if I had damaged my RF260 speakers or its internal components? Thanks.
  3. Hello all. So I recently bought the RC-64 and have come to a point where I need to make another configuration decision while re-architecting my center channel space; eg, hole still open for upgrade. So, the RC-64 has a 99dB sensitivity which provides 117dB@64watt or 120dB@128watt. My receiver has 110watt/channel(7ch) enough to power the center speaker to put out 117-120dB range. My receiver is capable of bi-wiring the front speakers, using front and rear-surrounds, but it does not say about the center. Since I'm using a dedicated 50watt amp for my front La Scalas, can I still use the freed front left and right channels to power/bi-wire my center? Thoughts and suggestion is much appreciated. Thanks! jav
  • Create New...