Search the Community
Showing results for tags 'powered speakers'.
Found 4 results
I have a R-41 PM and a R-120SW connected to my TV via optical. When watching movies the dialogue is very Low compared to my 5 year old soundbar. The two channel setup has a much more immersive experience but how do fix the dialogue issue I am having? Any advice or tips? If these speakers are just built this way do you think higher end models like the R-51PM or the Fives might make a difference? Cheers Yash
I have a R-41 Powered Monitors and a R-120SW connected to my TV via optical. When watching movies the dialogue is very Low compared to my 5 year old soundbar. The two channel setup has a much more immersive experience but how do fix the dialogue issue I am having? Any advice or tips? If these speakers are just built this way do you think higher end models like the R-51PM or the Fives might make a difference? Cheers Yash
I want to create a 2.1 sound setup for my computer, and I'm wondering what would be the best choice of speakers and subwoofer. Should I get a pair R-41PM or should I get normal speakers (non-powered) and also get tiny amp for the PC? Also, what subwoofer should I get? I'm looking for something small, since the only place I have is under the desktop. Also, how much do I need a subwoofer for PC listening? I would like to keep the budget around $400. I have one more question: Can I use a powered subwoofer with powered speakers? PS: I'm trying to build this audio setup with Black Friday if possible.
Hello Community, This is my first post and I'm hoping I can use your collective knowledge. I have a pair of Klipsch XF-48s and they are quite phenomenal still after 10 years. I've been moving around a lot over the past years and it's possible I did some unwitting damage to one of the RCA plugs. Long story short, I was running speaker wire (speaker level) to the speakers from a Pioneer Elite receiver, IMO they sounded better than being plugged in via RCA but I digress. Now, I've purchased a new preamplifier Schiit Freya+ and was going to let the speakers power themselves and be fed via RCA cables. One of the speakers is fine, the other had a loose plug (last time I checked that was not the case but again I digress), I was quite alarmed and hoped this is not massive damage. Good thing is that sound still comes through good and clear no hum through RCA on the speaker in question. I called Klipsch via telephone and was told I should try to take off the faceplate via the front screws to access a nut that would tighten the RCA plug from the backside. Not being able to remove the faceplate made think of different solutions. I double checked the RCA plug and saw there was some travel but would not travel beyond say 2mm at that point it was very secure. I thought perhaps to get a plastic or rubber washer between the RCA plug and make it secure. Nothing like that was available so, I thought I'd use an old credit card and see if it fits beneath the RCA plug and between the speaker housing, it did. So, I cut two thin strips and had one layer on both sides but it was not snug, I was without too much effort to double it up and the RCA plug is almost as secure as the "good" speaker. Is this a good DIY fix or am I putting undue stress on the plug or the internal wiring? Should I have superglued the plug to the back? I'd like to hear from the community and hopefully find an elegant but most importantly a good solution. Looking forward to your responses, thank you.