Jump to content

Search the Community

Showing results for tags 'RCA INTERCONNECT CABLES'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • Klipsch Announcements
    • Klipsch News
    • Klipsch Pilgrimage 2020
    • Klipsch Website & Forum Info
  • Klipsch Museum of Audio History
    • Klipsch Museum: News & Announcements
    • Ask the Historian
    • Klipsch Museum: General Discussion
  • Klipsch Audio
    • General Klipsch Info
    • 2-Channel Home Audio
    • Home Theater
    • Subwoofers
    • Architectural
    • Klipsch Pro Audio
    • Technical/Restorations
    • Headphones
    • Personal Music Systems
    • Talkin' Tubes
    • Solid State
  • The Klipsch Joint
    • Garage Sale
    • Lounge

Calendars

There are no results to display.


Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


Location


Interests


My System


See My System


Website URL


Twitter


Skype


AIM


Yahoo


MSN


ICQ


Jabber

Found 2 results

  1. Hello Community, This is my first post and I'm hoping I can use your collective knowledge. I have a pair of Klipsch XF-48s and they are quite phenomenal still after 10 years. I've been moving around a lot over the past years and it's possible I did some unwitting damage to one of the RCA plugs. Long story short, I was running speaker wire (speaker level) to the speakers from a Pioneer Elite receiver, IMO they sounded better than being plugged in via RCA but I digress. Now, I've purchased a new preamplifier Schiit Freya+ and was going to let the speakers power themselves and be fed via RCA cables. One of the speakers is fine, the other had a loose plug (last time I checked that was not the case but again I digress), I was quite alarmed and hoped this is not massive damage. Good thing is that sound still comes through good and clear no hum through RCA on the speaker in question. I called Klipsch via telephone and was told I should try to take off the faceplate via the front screws to access a nut that would tighten the RCA plug from the backside. Not being able to remove the faceplate made think of different solutions. I double checked the RCA plug and saw there was some travel but would not travel beyond say 2mm at that point it was very secure. I thought perhaps to get a plastic or rubber washer between the RCA plug and make it secure. Nothing like that was available so, I thought I'd use an old credit card and see if it fits beneath the RCA plug and between the speaker housing, it did. So, I cut two thin strips and had one layer on both sides but it was not snug, I was without too much effort to double it up and the RCA plug is almost as secure as the "good" speaker. Is this a good DIY fix or am I putting undue stress on the plug or the internal wiring? Should I have superglued the plug to the back? I'd like to hear from the community and hopefully find an elegant but most importantly a good solution. Looking forward to your responses, thank you.
  2. Howdy, I am looking to buy a quantity of 5 or 7, 6 foot (2 meter) good quality, RCA Interconnect cables (NO MONSTER). I am willing to pay up to $100 US with shipping. Thank you.---Ed
×
×
  • Create New...