Search the Community
Showing results for tags 'e'.
Found 2 results
Hey Everyone, I had such a great response from the forum last time I posted here that I decided instead of again suffering too much trying to figure out the answer myself I would again ask here (see below for my previous post). There is such a vast wealth of knowledge and experience here that I would be foolish to not ask for your insight and ideas. I want to do a refresh on my Klipsch Heresy I speakers crossovers, they haven't been touched since they were produced in 1977. I have decided that I want to do the following: - replace the Capacitors (100%) - replace the wire (maybe not but I kinda do) - understand what those strange things are look like metal frames holding a wound up paper with wires going into it (there are two of them, and they are the only other thing than the capacitors in the crossover, can these fail? should they be replaced?) - any success with replacing the terminals on the back of the speakers? Is this necessary? I feel like to be sure it would be good to replace them, but I hate the idea of changing the speakers too much, especially externally. So from what I understand is that many consider the Sonicaps too bright and therefore I have leaned towards two options: - Mundorf Silver in Oil - Jensen NOS Paper in Oil (if I can secure them) So the questions that I have currently are: - Have you tried the Mundorf or the Jensen? What caps have you had success with? - I need a parts list with specific measurements required and I can't decipher a electronic schematic, thank god I have a good and honest tech here locally so I can get the work done, soldering, ect. - any suggestions for wire that I should use internally for these speakers? I understand that it is better to have a bit of a smaller gauge especially when using a tube amplifier and highly efficient speakers. Should I keep the original? These speakers are in surprisingly good condition for their age... I'll ping the stand up guys that helped me the first time. Thanks guys! @JohnA @jimjimbo @CECAA850 @MC39693
Hello everyone, I bought a couple of Klipsch Heresy I 1972 (Tweeter: K77 Midhorn: K700 plus K55V driver, woofer: K22E alnico NOT RED SURROUND OF H700 Model) They have Type C crossovers but the woofers impedance is 8 ohm. Do I have to change the crossovers on type D or E configuration?