Jump to content

Search the Community

Showing results for tags 'high surrounds'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • Klipsch Announcements
    • Klipsch News
    • Klipsch Pilgrimage 2020
    • Klipsch Website & Forum Info
  • Klipsch Museum of Audio History
    • Klipsch Museum: News & Announcements
    • Ask the Historian
    • Klipsch Museum: General Discussion
  • Klipsch Audio
    • General Klipsch Info
    • 2-Channel Home Audio
    • Home Theater
    • Subwoofers
    • Architectural
    • Klipsch Pro Audio
    • Technical/Restorations
    • Headphones
    • Personal Music Systems
    • Talkin' Tubes
    • Solid State
  • The Klipsch Joint
    • Garage Sale
    • Lounge

Calendars

There are no results to display.


Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


Location


Interests


My System


See My System


Website URL


Twitter


Skype


AIM


Yahoo


MSN


ICQ


Jabber

Found 1 result

  1. Is it possible to run a 5.1 setup with the surround sound speakers being set / placed / used as the "high surround speakers". I was playing with my AVR last night and could get the receiver to recognize and play test tones through the speakers set as high surrounds but only that was only an option after selecting I did in fact also have typical surrounds. The receiver would only play the test tones through the setup as I intended it to be and not try to search for / find the typical surrounds but after completing the Audssey calibration however it wouldn’t recognize the speakers at all. This was while trying to run the corrected Audssey calibration and dynamic eq; which is how I preferred to run the system. I did not however try or recall the system recognizing the system as I intend in the manual set up. I played around with the audio formatting (DTS, DTS-HD and so on) and never could get the receiver to recognize the speakers / sound to come out. I tried this on HD cable shows, Blu-ray movies in both 5.1 and 7.1 through my PS3 and PS4, and even tried it through internet radio. Is this just not a typical 5.1 setup? Is it an audio formatting issue with trying to do a 5.1 with high surrounds? Is the use of “high surrounds” only limited to a true 7.X and higher speaker setups? Of note, I prefer to run the setup in this manner because I am renting so therefore prefer not to rip up carpet, I live in a two story house and the living room in on the first floor so I think going over head is also out of the question. Also the way the living room is set up it would be a nightmare to try and run along or behind the base boards; but I guess that is my only option if I can’t run this set up as I prefer. Any suggestions or ideas would be greatly appreciated!
×
×
  • Create New...