Search the Community
Showing results for tags 'homemade'.
Found 3 results
As can be clearly seen, the need to do something became over due. The Ikea rack takes up way too much space and, obviously, can´t cope with the 130lbs pf CRT-TV. The positioning of my center is also less than optimum. So i surfed the net a bit and found a solution for DIY that i can pull through, although my skills and tools are limited. The main components will be multiplex wood and threaded rods. I hope to come out with a rack that will be both cheaper and more durable than the ones you can buy. These are two of four plates i plan to use. Holes are already drilled and the left received the first coat of oil. Plates are birch and approx. 110cm/ 43" x 40cm/ 16", the uppermost is 3cm/ 1,2" thick, the others are 2cm/ 0,79". Connecting rods will be M16/ 5/8".
Hey my fellow speaker tinkers.... so, i finally got off my lazy butt and made my Cat 5/6 speaker cables. i will say i was surprised at the results. don't get too excited though, i was comparing them to Mil Spec wire (12awg, twisted, shielded). the difference between these two were night and day. i am happy to say that even my wife could hear a drastic difference. the volume seemed to be "louder", clarity was through the roof, and even the bass was kicked up. all this could be heard during an HT demo! usually cable upgrades have to be tested through a 2ch A/B to really hear a difference. most of you know this through my "Power Cable Test Kit" post. anyways, i used 4 pairs of twisted Cat 5 pairs to make 1 leg. then i took 4 legs and twisted them into a Star Quad design. so that's 16 pairs or 12awg. i also did the same thing with Cat 6 23awg and that comes to 11awg. i am going to switch out my Cat 5 cables for Cat 6 because of a few OCD reasons. i like the Teflon jacket more, i like how the colors look (over all appearance), all 4 pairs are twisted the same (cat 5 has 2 pairs twisted more tightly). i highly double there is an audible difference, and i won't even do an A/B test. i used a vice and a drill. took about 1 hour to make the cable, comb out the ends, strip them, and install banana plugs. so, much quicker than braiding them! the final design is pretty cool because the 4 legs twisted together open up a touch and make an air gab in the center. i've read that's a good thing, but i don't know the science behind the answer. again, super cheap, easy, quick, and there is a noticeable sound difference between Cat 5/6 and cheaper speaker cables.
So I saw a listing this morning for replica Klipschorn cabinets, made to PWK specs. No drivers or crossovers. The owner recommends re-veneering since they were built 30 years ago. Would you go for it? If so, what would be your total budget for the cabs, drivers and crossovers? How much work would it take to do it right?