Jump to content
The Klipsch Audio Community

Search the Community

Showing results for tags 'r-26fa'.

More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


  • Klipsch Announcements
    • Klipsch News
    • Klipsch Pilgrimage 2020
    • Klipsch Website & Forum Info
  • Klipsch Museum of Audio History
    • Klipsch Museum: News & Announcements
    • Ask the Historian
    • Klipsch Museum: General Discussion
  • Klipsch Audio
    • General Klipsch Info
    • 2-Channel Home Audio
    • Home Theater
    • Subwoofers
    • Architectural
    • Klipsch Pro Audio
    • Technical/Modifications
    • Headphones
    • Personal Music Systems
    • Talkin' Tubes
    • Solid State
  • The Klipsch Joint
    • Garage Sale
    • Lounge


There are no results to display.

Find results in...

Find results that contain...

Date Created

  • Start


Last Updated

  • Start


Filter by number of...


  • Start





My System

See My System

Website URL








Found 1 result

  1. First off, I am an audio idiot. I am in the process of replacing speakers that I bought in the mid-90's. Therefore, I will apologize in advance if this all just sounds stupid to those of you who are experts in this area. I bought an OLED television and a Yamaha RX-V683 receiver as I'm trying to upgrade the sound to match. On the advice of B&H, I purchased the R-26FA floor standing speakers, as well as a center speaker. The rear speakers are still in transit, so I haven't connected those yet. But as for the R-26FA speakers, they have six posts (three sets) on the back for connecting wires. The instructions say: Some Klipsch Reference speakers come with dual binding posts that are connected by a metal strip. Do not remove this strip or your speakers will not function correctly. Keep this strip in place and connect your speaker wire to the top set of the binding posts. It is possible to “Bi-wire” a speaker that has two sets of binding posts. Please see your receiver’s manual for further instructions Ok, so I connected my receiver to the top set of posts, which sit alone. Now the sound comes out of the top of the speakers (the elevated one that lies on something like a 45 degree angle). However, shouldn't the front of the speakers be putting out sound as well? Or is that only for bi-amping? Should I be hooking up additional wires from the receiver to these other posts? Compared to my vintage 1996 speakers, this sounds pretty great, even without the rear speakers in place yet. But I have a feeling I'm doing this wrong and would like to get the most out of these. Support is closed until Tuesday, so I'm hoping someone can give me some advice. Thank you.
  • Create New...