justinsweber Posted October 11, 2009 Share Posted October 11, 2009 I used some plans I was given that were good to go and took these down to my cabinet maker. The are roughly cornwall demensions. 34 x 24 x 13... is this too small to make into cornscalas... Im very new to this and dove in too fast. I hope and pry they will allow me to change the build to 24in deep... but may not. Will the smaller size work for bob's version on a cornscala? CW1526C Cast Frame Woofer, CT125 Tweeters, Atlas PD-5VH Midrange Driver, PH-800 Horn Im so Fing worried now! Thank you for the help. Justin Quote Link to comment Share on other sites More sharing options...
Guest David H Posted October 11, 2009 Share Posted October 11, 2009 You are correct, the cab is too small, unless those are the internal box dimentions. Quote Link to comment Share on other sites More sharing options...
HudsonValleyNoah Posted October 11, 2009 Share Posted October 11, 2009 http://www.kcnproducts.com/KCN-Products-MG-Electronics-PH-800-p/kcn-ph-800.htm If those are the internal box dimensions, it just might make it with this horn that you listed. Is this horn of yours a 400 Hz horn, or higher? Quote Link to comment Share on other sites More sharing options...
Mike Dubay Posted October 11, 2009 Share Posted October 11, 2009 There are options here. You could mount the horn on top of the cabinet, with out the horn taking up some of the volume it would add some volume to the cabinet. Quote Link to comment Share on other sites More sharing options...
jhoak Posted October 12, 2009 Share Posted October 12, 2009 Here's a set of drawings that turned up on another forum... Cornwall_Plans.pdf Quote Link to comment Share on other sites More sharing options...
justinsweber Posted October 12, 2009 Author Share Posted October 12, 2009 My Cabinet guy was really nice and worked with me… We punched out the internal dimensions to 24.o” wide x 34.0” tall x 14.0” deep. Outside dimensions will be adjusted to make the inside work. This will be made with ¾ MDF for inside of cabinet, and ¾ birch plywood on outside. Loosely based on cornwall plan… with dimensions changed to made 34x24x14 inside as a cost of $131 per cabinet… I got a great price. (Including back and front panels.) Should have later this week. By my calculations that’s 11424cu in = 6.61 cu ft. This seems closer I hope? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.