stormgas Posted September 30, 2013 Share Posted September 30, 2013 I have a problem with my headphones... After pairing to the first device (e.g. to my samsung Note II) it works well but it is not possible to connect my headphones to another device after that because when I switch them on and try to find them inside a list of available devices I can not find them in it. I tried several devices of different producers but each time when I want to connect another device (but not the last paired one) I have to clear the list of remembered devices inside my headphones by pushing buttons "Vol-" and "Power" together during 8 seconds and then again... I think the headphones should be visible for recognition by other devices when they swithed on and there is no any known devices in range (which has been already paired once) because according the manual headphones are able to keep in memory 8 BT devices. So, how can I connect another device without clearing the memory of headphones? Quote Link to comment Share on other sites More sharing options...
ChargerDad Posted January 17, 2014 Share Posted January 17, 2014 I am having the same exact problem, very frustrating.. I have two pairs of these and one more on the way, but with not working with multiple devices I'm getting frustrated.. Quote Link to comment Share on other sites More sharing options...
Schu Posted January 17, 2014 Share Posted January 17, 2014 I would say that perhaps you might not be "adding" the new devices into the system correctly. are you sure you are trying to "add" a new device following the correct procedure? Quote Link to comment Share on other sites More sharing options...
aiellocj Posted January 31, 2014 Share Posted January 31, 2014 Hi stormgas & ChargerDad, Sorry to hear of your difficulties with the Image ONE Bluetooth pairing. Hopefully I can help you resolve the issue. Let's start with the very basics. Each time you go to pair it with a new device, are you ensuring that you properly put the headphones in pairing mode and see the LED indicator rapidly blinking red/blue? Quote Link to comment Share on other sites More sharing options...
tmassey Posted February 1, 2014 Share Posted February 1, 2014 I had the same problem. I realized that I was not holding the power button long enough. Try turning them off completely, and then holding the power button to turn them on but keep holding it to get them into the pairing mode. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.