Jump to content


Photo
- - - - -

Industrial La Scalas?


  • Please log in to reply
36 replies to this topic

#21 minermark

minermark

    Bi-Amped, Active, Tube pumped and Done

  • Members
  • PipPipPipPipPip
  • 3,992 posts
  • LocationRoseville Calif
  • Offline

Posted 31 January 2014 - 09:00 PM

t three more Guinness's before I look inside.

Only ten year old bourbon qualities you as a repair tech :D

as one ham to another K1WME whiskey mike echo

Lagavulin 16 on this end.

My lic: a letter, a number and two more letters. Don't really wish to publish the homestead.


Edited by minermark, 31 January 2014 - 09:09 PM.

 One Pizzed off Neighbor and Counting :rolleyes:


#22 mach-1

mach-1

    Forum Veteran

  • Members
  • PipPipPipPip
  • 1,004 posts
  • Offline

Posted 31 January 2014 - 10:07 PM

This a dead thread, Cl is is a dead horse but My 2 M amp 829B resides on top of right K-horn....Millen 829B:

P1000439_zps0eda8ce4.jpg


Edited by mach-1, 31 January 2014 - 10:12 PM.


#23 ellisr63

ellisr63

    Forum Veteran

  • Members
  • PipPipPipPip
  • 1,472 posts
  • LocationIn the Home Theater
  • Offline

Posted 31 January 2014 - 10:12 PM

I didn't realize the Industrial didn't go as far down as the consumer version. OOPS... I just looked up the specs and they are the same... For some reason I was thinking they went to 35hz. I know my Denon set my center to 40hz.


Edited by ellisr63, 31 January 2014 - 10:14 PM.

tia,
Ron
Our Home Theater setup 

LCR 1/4 pie bass bins  with JBL 2360a horns, and EV DH1a drivers
Heresy HIP for side surrounds and rear surrounds
2 Danley DTS-10s
Denon 4520ci
Yamaha P7000S amp (for subs)
(2) Yamaha P2500s amps (for 1/4 pie)
3 Topping 25wpc amps (for JBL 2360A)
3 2x4 minidsp crossovers
Panasonic AE8000
Seymour 15' wide scope screen/wall


#24 CECAA850

CECAA850

    Klipsch Forum Lifer Carlooch

  • Moderators
  • PipPipPipPipPipPipPipPip
  • 18,156 posts
  • LocationSoutheast TX
  • Offline

Posted 31 January 2014 - 10:27 PM

If you had a Lascala that was flat to 35 Hz, you'd have something special.


A Harmony One remote runs a............. Pioneer Elite KURO 150FD display. Anthem D2 pre-pro. 4 QSC PLX 1104 amps. Oppo BDP-80 Blu-ray player. Toshiba XA2 HDDVD player. IB sub with 4 Ascendant Audio 18" drivers powered by a Behringer EP-2500. 2 Klipsch Dean G'd RF-7's, 1 Dean G'd RC-7, 2 RS-7's and 2 RB-35's, all protected by a Furman Elite 20-PFi

Bedroom 1, Lascalas w/ ALK networks and Crites tweeters, Juicy Music modded Crown D-45, Njoe Tjoeb CD player and an Anthem TLP-1. Tuba 18 sub powered by a Behringer A-500.

Bedroom 2, Heresy II's with III upgrade, Carver TFM-15, Carver CT-6 and a Sony CDP C235.

Bedroom 3, under construction.

#25 mach-1

mach-1

    Forum Veteran

  • Members
  • PipPipPipPip
  • 1,004 posts
  • Offline

Posted 31 January 2014 - 11:09 PM

Out side LS Pro -5dB @ 60 hZ inside - 5dB @ 42 hZ w/K43 LS needs a SUB but it is a #10 at design parameters

bigwoofer_zps58979b73.jpg



#26 Islander

Islander

    Klipsch Fanatic

  • Members
  • PipPipPipPipPipPip
  • 6,083 posts
  • Offline

Posted 01 February 2014 - 01:37 AM

More info on that big speaker: http://audio-databas...sp/d-160-e.html

The matching tweeter: http://audio-databas...tonesp/d-80.JPG

The set: http://www.ibrony.co...cfd75e1_500.jpg


Pat on the Island

 

510 JubScala IIs + Paradigm PW-2100 V.2, powered by Yamaha MX-D1 x 2, EQ'd by Electro-Voice Dx38, controlled by Yamaha RX-V750, fed by Technics SL-1210M5G & Yamaha DVD-S550

 

6.1 Surround: above plus Belle (centre front), La Scalas (left and right surround), Heresy III (centre rear)


#27 ellisr63

ellisr63

    Forum Veteran

  • Members
  • PipPipPipPip
  • 1,472 posts
  • LocationIn the Home Theater
  • Offline

Posted 01 February 2014 - 01:41 AM

If you had a Lascala that was flat to 35 Hz, you'd have something special.

My center channel is mounted on its side and the Denon sets it to 40hz, while the other La Scalas are set to 60hz. The only other difference is the center is a Rodgers La Scala which has an identical crossover.


tia,
Ron
Our Home Theater setup 

LCR 1/4 pie bass bins  with JBL 2360a horns, and EV DH1a drivers
Heresy HIP for side surrounds and rear surrounds
2 Danley DTS-10s
Denon 4520ci
Yamaha P7000S amp (for subs)
(2) Yamaha P2500s amps (for 1/4 pie)
3 Topping 25wpc amps (for JBL 2360A)
3 2x4 minidsp crossovers
Panasonic AE8000
Seymour 15' wide scope screen/wall


#28 minermark

minermark

    Bi-Amped, Active, Tube pumped and Done

  • Members
  • PipPipPipPipPip
  • 3,992 posts
  • LocationRoseville Calif
  • Offline

Posted 01 February 2014 - 03:45 AM

This a dead thread, Cl is is a dead horse but My 2 M amp 829B resides on top of right K-horn....Millen 829B:

P1000439_zps0eda8ce4.jpg

If you had a Lascala that was flat to 35 Hz, you'd have something special.

My center channel is mounted on its side and the Denon sets it to 40hz, while the other La Scalas are set to 60hz. The only other difference is the center is a Rodgers La Scala which has an identical crossover.

I have not seen that kind of equipment since I was a youngin, except at the TRW swapmeet in ElSegundo.

When I think back to the early days, I remember begging my dad for equipment not much different form this.

Amazing what we could do in those days with an AirCap and a few tubes........


 One Pizzed off Neighbor and Counting :rolleyes:


#29 minermark

minermark

    Bi-Amped, Active, Tube pumped and Done

  • Members
  • PipPipPipPipPip
  • 3,992 posts
  • LocationRoseville Calif
  • Offline

Posted 01 February 2014 - 03:47 AM

Out side LS Pro -5dB @ 60 hZ inside - 5dB @ 42 hZ w/K43 LS needs a SUB but it is a #10 at design parameters

bigwoofer_zps58979b73.jpg

Man, what I could do with that critter.


 One Pizzed off Neighbor and Counting :rolleyes:


#30 mach-1

mach-1

    Forum Veteran

  • Members
  • PipPipPipPip
  • 1,004 posts
  • Offline

Posted 01 February 2014 - 09:34 AM

I have not seen that kind of equipment since I was a youngin

Those were the days, I remember seeing the Millen amp in the ARRL Handbook. It was a about $81, 100 watt final for my 2 meter rig.



#31 mach-1

mach-1

    Forum Veteran

  • Members
  • PipPipPipPip
  • 1,004 posts
  • Offline

Posted 01 February 2014 - 09:38 AM

ore info on that big speaker: http://audio-databas...sp/d-160-e.html

I like the "low pass play limit 8Hz" :D

System 1 way, 1 speaker bass-reflex system, and a floor type Use unit For low-pitched sound: 160cm honeycomb corn type (PW-1600) Low-pass play limit 8Hz The maximum input 3000W


Edited by mach-1, 01 February 2014 - 09:39 AM.


#32 minermark

minermark

    Bi-Amped, Active, Tube pumped and Done

  • Members
  • PipPipPipPipPip
  • 3,992 posts
  • LocationRoseville Calif
  • Offline

Posted 04 February 2014 - 05:20 AM

Out side LS Pro -5dB @ 60 hZ inside - 5dB @ 42 hZ w/K43 LS needs a SUB but it is a #10 at design parameters

bigwoofer_zps58979b73.jpg

Man, what I could do with that critter.

When I see 'Lifting' rings on top of a speaker, im in heaven.


Edited by minermark, 04 February 2014 - 05:21 AM.

 One Pizzed off Neighbor and Counting :rolleyes:


#33 ClaudeJ1

ClaudeJ1

    Forum Ultra Veteran

  • Members
  • PipPipPipPipPip
  • 3,957 posts
  • Offline

Posted 13 February 2014 - 02:06 PM

No changes needed.

and you will get a better midrange sound and slightly thinner bass.


2.1/6.1=Front R+L=Sound Physics Labs (SPL) TD-1, Center=SPL Runt, SR, SL, and RC=Super Heresy's. All driven by Onkyo 818 AVR Amp section. Twin Danley DTS-10 Super Spud Subs front R and L side walls in corners driven by 0.2 Pre-Outs to Bryston 4B.
Oppo 83 SE with Sabre DACs for CD 2.1, HDMI out for 6.1 to Onkyo DSP's. Audyssey Multi EQ/XT32 room correction for ALL listening.

#34 ClaudeJ1

ClaudeJ1

    Forum Ultra Veteran

  • Members
  • PipPipPipPipPip
  • 3,957 posts
  • Offline

Posted 13 February 2014 - 02:09 PM

If you had a Lascala that was flat to 35 Hz, you'd have something special.

Yeah, like gross PEQ. A 2.6 foot horn rolls off at over 100 Hz.. Below that, it's a direct radiator in a sealed enclosure feeding a small slot in a very tight corner.


2.1/6.1=Front R+L=Sound Physics Labs (SPL) TD-1, Center=SPL Runt, SR, SL, and RC=Super Heresy's. All driven by Onkyo 818 AVR Amp section. Twin Danley DTS-10 Super Spud Subs front R and L side walls in corners driven by 0.2 Pre-Outs to Bryston 4B.
Oppo 83 SE with Sabre DACs for CD 2.1, HDMI out for 6.1 to Onkyo DSP's. Audyssey Multi EQ/XT32 room correction for ALL listening.

#35 djk

djk

    Klipsch Fanatic

  • Members
  • PipPipPipPipPipPip
  • 5,679 posts
  • Offline

Posted 14 February 2014 - 08:06 PM

"and you will get a better midrange sound and slightly thinner bass."

+1


Golden Ear Audiophile hit with a brick "Oww, that hurts! I'm bleeding!" Tin Ear Meter Reader hit with a brick "You can't prove I was hit with a brick! We need to do a double blind ABX test!"

#36 Randyh

Randyh

    klipsch Forum Veteran

  • Members
  • PipPipPipPip
  • 1,068 posts
  • LocationNY
  • Offline

Posted 25 May 2014 - 12:25 AM

here is a thread about the specs of the k43 woofer - the rating is 400 watts power handling - 3 inch voice coil - yep the midrange is much better than a k33 - some say less bass -

-https://community.kl...390-k-43-specs/


Edited by Randyh, 25 May 2014 - 12:56 AM.


#37 mdross1

mdross1

    Advanced Member

  • Members
  • PipPipPip
  • 82 posts
  • Offline

Posted 06 June 2014 - 07:50 AM

One thing is for certain these LaScalla's with very little power sure beat on the chest cavity. Real anxious to hear the difference with subs that will get down into the range where the Lascalla's leave off.