Jump to content

Anyone use EV 6NDX Compression Driver?


longdrive03

Recommended Posts

For PA the minimum suggested crossover point is 1Khz.

For home use you might get away with 500hz. I have a friend using the DH7 (same diaphragm) at 750hz/24dB and is happy with it for home use.

023.jpg

Edited by djk
Link to comment
Share on other sites

  • 3 months later...

EV data shows the ND6x for use down to 500Hz. at power of 50 watts for situations where lower crossover than the ND6 which crosses at 1000 Hz and will take 75 watts. ND6x looks similar to the DH1A. Weighs a lot less than a DH1A. I would have liked to think that after all these years the ND6x would show more improvement over the DH1A, goes to show what a fine job they did on the DH1A.. Best regards Moray James.

Link to comment
Share on other sites

Thanks djk. I've thought about using them in a Jube if I get enough time and strength to try to build a pair. Does the DH7 cover 750Hz to 20khz? I may mate it with an EV SMX 2151 15" woofer which is about 98db.

If you end up going the Jubilee-route, I would discourage you from a crossover at 750Hz. You would want to go lower.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...