Jump to content
The Klipsch Audio Community
Sign in to follow this  
MercedesBerater

Home theatre build....DIY..slowly..

Recommended Posts

It sounds like my same build. When I looked at your framed out walls, I thought it was my basement! I also did it myself (along with the entire basement) and it took

2 years. 

I started with a brick ranch with a full unfinished basement and a center post supported load bearing beam. I removed a dropped ceiling and built insulated outside walls and double staggered stud inside walls with two layers of 5/8inch drywall with Green Glue on each side of the wall.  My room is 12.6 wide and 21 deep and I could only get the ceiling up to 7' 6" high. I also had to re-route 25 ft of trunkline and several heat runs to make the theater room as unobstructed as possible.

Because I put the equipment rack under the stair well, I had to completely rebuild my old staircase and finish it out the same as the side walls. The ceiling is also two layers.

The room has 6 seats, 3 being on a riser. I insulated the riser and added led lights at the base. The theater is painted a flat light grey (ceiling and walls) but the screen wall and 6ft. of the ceiling and side walls are flat black. 

I made bass traps for the side walls (4) and corner traps in the vertical corners and horizontal ceiling corners with acoustical rock wool and fiberglass.

All joints were caulked so well with Green Glue caulk that I think the room might actually be able to hold water.

My ceiling is so low that my screen frame is only a couple inches from the ceiling. 

For lighting, I added 8 light cans with a rf controller. Since the room was completed, I've added 6 speakers and changed my AV receiver.

I have to say that I will probably not see the inside of a commercial theater again (Iam 67), and I won't miss having to climb into a freezing car on a cold, windy winter night for the drive home. My wife and I love movies and this was the best investment I ever made!

My theater consists of the following:

Projector....JVC 56U

Screen.......Stewart Studiotek G130 (120 inch)

Blue ray.... Oppo 103D

AV.............Onkyo TX 3030

Speakers

Mains............Klipsch RF-83

Center...........Klipsch RC-64

Sub...............RT-12D

surrounds.....RS-62

rear surrounds.....5650 W-ll

Overheads (4).....5650  W-ll

TV Room

Display.........LG EF6500 4k OLED

AV................Onkyo tx5800

Blue ray.......Oppo 95

Speakers.....Onkyo (replacing)

 

 

 

 

 

Share this post


Link to post
Share on other sites

You are moving along!  My hat is off to you guys doing complete theater builds.  It is a lot work.  I just got a projector and I am complaining about running wires, patch walls, ect.  This may lead to me repainting the whole room. :(   Keep the pic's coming. :)

  • Like 1

Share this post


Link to post
Share on other sites

Tell my wife to let the funds keep coming? Hah!

Next up is rear riser....

Then with tax refund will be getting either/or projector or carpeting. (This project would be much faster if I could afford to hire it out, and my wife was done with college!)

But doing it ALL myself is half of the fun of the project.... And me working on the theater leaves her alone to study.

  • Like 1

Share this post


Link to post
Share on other sites

Looks very nice. It's rewarding doing all that work yourself, and something to be proud of, not everyone can do that.

  • Like 1

Share this post


Link to post
Share on other sites

Column lights are up... Dimmable of course.

Picked up last 7 sheets of 5/8" drywall & 7 tubes of GG to finish the back wall.

Should be working on the rear riser in a month or so...

post-60770-0-83000000-1451254775_thumb.j

post-60770-0-41400000-1451254801_thumb.j

post-60770-0-48200000-1451254817_thumb.j

Share this post


Link to post
Share on other sites
But not bad I suppose

 

Not considering I started mine a little over two years ago and I all I have is framing, and all the wiring. 

Share this post


Link to post
Share on other sites

Absolutely love the Festool. It's like an electric turkey knife cutting through butter!

 

I keep trying to wear out my old Craftsman so I can justify buying one of those.  I have one of their track saws and absolutely love it.

Share this post


Link to post
Share on other sites

Last 7 sheets of drywall going up.... Will mud/tape on Sunday & hope to have paint rolled on in another week.

The door on the rear wall (left side of pic) is TOTALLY temporary. I'll be doing communicating doors. (Like in a hotel room)

Next up: Rear riser!

post-60770-0-97360000-1451696487_thumb.j

post-60770-0-94040000-1451696498_thumb.j

Edited by MercedesBerater
  • Like 1

Share this post


Link to post
Share on other sites

Ugh??? Why does it rotate and 90* turn pics randomly... Oh well. I only use my phone for this forum... So I'm not attempting to fix.

You'll just have to turn your monitor :D Lol.

  • Like 1

Share this post


Link to post
Share on other sites

Rear riser... Used 4 bags of R-13 JM fluffy. And one bag of Rockwool.

2 layers of 1/2" OSB with green glue in between. (This picture only has the first layer of OSB)

post-60770-0-61920000-1454891540_thumb.j

post-60770-0-42160000-1454891566_thumb.j

post-60770-0-52520000-1454891589_thumb.j

post-60770-0-56480000-1454891613_thumb.j

  • Like 1

Share this post


Link to post
Share on other sites

Certain phones do it. My samsung galaxy note 5 does it. I just rotate the phone 90 degrees.

Looking good though.

Sent from my SM-N920P using Tapatalk

Share this post


Link to post
Share on other sites

how tall is your riser? mine is 2x12's with 3/4" ply on top and then 1/2" pad with really thick carpet and i find it just barely tall enough to clear the front row. i wish it was taller but same ceiling height as you. 

Share this post


Link to post
Share on other sites

7" total height before carpet.

Unfortunately I can not go any higher due to height limitations. The center support beam for the house with hvac trunk runs overhead.

I'm 6'0" And when standing on the rear riser I have a few inches of head clearance to walk to a seat and sit down.

Share this post


Link to post
Share on other sites

7" total height before carpet.

Unfortunately I can not go any higher due to height limitations. The center support beam for the house with hvac trunk runs overhead.

I'm 6'0" And when standing on the rear riser I have a few inches of head clearance to walk to a seat and sit down.

you gonna try seating before you continue? I guess depending on your screen you could go higher. My screen is about 6-7" from ceiling but was high as it could be. We built first rider from 2x8'd and it was just unwatchable for me in the back row. Although I'm only 5'7".

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

×
×
  • Create New...