Jump to content
The Klipsch Audio Community
Sign in to follow this  
lightsolutions

Klipsch atmos speakers - in ceiling - what should I get?

Recommended Posts

Hey,

Still deciding what atmos speakers I should get. I can definitely go in ceiling which is a plus.

Does anyone have any experience with any in ceiling speakers.

I'm thinking about getting th CDT-5800c-ii

I will have the front half of the system as Rf-7ii and rc-64ii.

Surrounds as Rs-52ii rear surround and Rs-62ii as side surrounds.

Planning for a 7.2.4 setup

Cheers

Share this post


Link to post
Share on other sites

Thanks fuzzydog! I actually just came across this before you posted. Your setup is actually very close in what I want to create. I was thinking maybe the cdt5650's recently as the woofer size will match the centre and side surrounds. Was there any particular reason you went the cdt5650s instead of the model up, the cdt5800's?

Did you end up finding a suitable amp to drive the 11 channels? That's on my list atm

Cheers

Share this post


Link to post
Share on other sites

Thanks fuzzydog! I actually just came across this before you posted. Your setup is actually very close in what I want to create. I was thinking maybe the cdt5650's recently as the woofer size will match the centre and side surrounds. Was there any particular reason you went the cdt5650s instead of the model up, the cdt5800's?

Did you end up finding a suitable amp to drive the 11 channels? That's on my list atm

Cheers

I just didn't think there would be an audible difference. They will be crossed over at 80 hz or higher so i wouldn't need the extra low frequency extension of the 5800. They two models are also very close in sensitivity and have the same tweeter.

I'm still trying to figure of the best amplification for my system.

  • Like 1

Share this post


Link to post
Share on other sites
Thanks fuzzydog! I actually just came across this before you posted. Your setup is actually very close in what I want to create. I was thinking maybe the cdt5650's recently as the woofer size will match the centre and side surrounds. Was there any particular reason you went the cdt5650s instead of the model up, the cdt5800's?

Did you end up finding a suitable amp to drive the 11 channels? That's on my list atm

Cheers

I just didn't think there would be an audible difference. They will be crossed over at 80 hz or higher so i wouldn't need the extra low frequency extension of the 5800. They two models are also very close in sensitivity and have the same tweeter.

I'm still trying to figure of the best amplification for my system.

Thanks fuzzydog! I'll check the pricing for 5650's and might go that route :) thanks for the advice.

Cheers

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

×
×
  • Create New...