Boxoffice Buff Posted January 17, 2017 Share Posted January 17, 2017 Hello All: I was calibrating my room acoustics using Yamaha YPAO (RXV-673). In the user manual, one of the steps to undertake before turning on the YPAO calibration says this... "Turn on the subwoofer and set the volume to half. If the crossover frequency is adjustable, set it to maximum." My question is - once the YPAO calibration is completed, do I need to adjust these settings or leave it the way it is recommended here? Before running YPAO, I had manually set the crossover frequency to 80 hz on my sub. Should I leave it at maximum? Thanks. Tejas Quote Link to comment Share on other sites More sharing options...
NBPK402 Posted January 17, 2017 Share Posted January 17, 2017 I think they are telling you to set it at max so it is taken out of the equation. You should only adjust level after YPAO if needed IMO. Quote Link to comment Share on other sites More sharing options...
Boxoffice Buff Posted January 18, 2017 Author Share Posted January 18, 2017 20 hours ago, ellisr63 said: I think they are telling you to set it at max so it is taken out of the equation. You should only adjust level after YPAO if needed IMO. Thank you. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.