Tommy39 Posted January 30, 2017 Share Posted January 30, 2017 Hi, I am new to the setup of my home theatre system. I have an AV receiver Yamaha A1060, RF260 floor standing speakers, RP250C, R14-S surround, R-10SW. I was so careless that I didn't remove the jumpers when doing a bi-wire. While doing the YPAO with a mic on the Yamaha, the AV receiver shuts down when it was half way doing the calibration. I didn't realised it was the jumpers, the receiver was showing "Check SP wire". I did the YPAO a few times (The receiver shut down a few times). I just wanna to ask if I had damaged my RF260 speakers or its internal components? Thanks. Quote Link to comment Share on other sites More sharing options...
The History Kid Posted January 30, 2017 Share Posted January 30, 2017 Do you think you did any damage? Does it sound like you did? Pass on the bi-wiring, you aren't going to benefit from it. It only creates more of a hassle trying to figure out where an issue is and makes more of a tangled up mess with wires. Quote Link to comment Share on other sites More sharing options...
derrickdj1 Posted January 30, 2017 Share Posted January 30, 2017 You can bi-wire or bi-amp the speakers. The jumpers need to be off for bi-amping or you can fry the tweeter. The jumpers can be on for bi-wiring. Give a more detailed response on the connections. Quote Link to comment Share on other sites More sharing options...
Tommy39 Posted January 31, 2017 Author Share Posted January 31, 2017 Hi, Thank you for the reply. I had followed the manual from the Yamaha A1060 and Klipsch, the extra pair of speaker wires were connecting the lower pair of RP260 binding posts to the Yamaha "Front Presence" binding posts labelled "SP1". Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.