Jump to content

Closed


A1UC

Recommended Posts

Doing a huge down size on my audio gear I'm selling pretty much my whole 2 ch setup , going to stick with a vintage setup and my headphone setup for now .
 
$4300.00 is what I need to end up with
 
 
PRP Resistor and Power Supply Bypass Cap Upgrade
 
 
 
Jupiter Caps
 
 
 
Grain Match Front Of Amplifiers
 
 
 
Upgraded Footers
 
 
 
Custom Magnequest Transformers
 
 
 
Cardas Speaker Binding Posts
 
 
 
Furutech RCA Inputs
 
 
 
Furutech IEC's
 
 
 
Last Upgrade Done was $3000.00   2/29/16
 
That was for the Transformers and binding posts .
 
The VRDS have some scratches but can be fixed pretty easy , I purchased the oil already . I can do this or the new owner can . The scratches are on the side so it never bugged me
 
fb97dcaee6ffae0bf8b8e9008584124d.jpg366532d36f4b24398119d00a4808f584.jpgf1b5f7eb64b33d1f22a3bb4fa4b61b9d.jpg

Tubes?

Sent from my SM-G935V using Tapatalk

Link to comment
Share on other sites

  • 4 weeks later...

Certainly can't speak for A1 but when other gear arrives and/or takes the place of, then they gots to go. I just sold monoblocks and two pairs of Klipsch speakers as they have been superseded or not being used. And looking to sell another amp/preamp combo. I finally had to realize I am not a retailer or collector and am getting too old to have things sitting around just to say I have this and this and that. 

And for Mr. A1 the Pass amp he just showed probably leaves him with little need for VRD's, but I'm just guessing.

  • Like 1
Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
×
×
  • Create New...