Deang Posted February 17, 2018 Share Posted February 17, 2018 Nice job on the layout - pretty much how I do it. Looks like a nice build to me - good job. Now about out that red cap ... :-) Quote Link to comment Share on other sites More sharing options...
avguytx Posted February 17, 2018 Author Share Posted February 17, 2018 Thank you sir. So you're saying I need to swap it out for an Audyn Plus? Lol Quote Link to comment Share on other sites More sharing options...
avguytx Posted March 21, 2018 Author Share Posted March 21, 2018 Well, my Belle's have been stored away at my best friends house along with quite a bit of other gear until our new house is built. Sigh. At least I got to hear them for a little while. 1 Quote Link to comment Share on other sites More sharing options...
NBPK402 Posted September 17, 2018 Share Posted September 17, 2018 On 9/23/2017 at 6:38 PM, avguytx said: And there you have it....all 36 pieces cut out for a pair of Belles. Still have the angles on the ramps to do plus dog house angles, woofer holes to cut out, etc, etc. But I got a lot done in 5 hours including breaks. Ha. Damn hot outside here. The only angles are the dog house then, correct? What are the angles? If I only have to do angles on the dog house, and ramps, cut holes for woofer, and the slot...I might be able to just get the wood all cut, and then route the angles on my router table. That is if it is an angle I can get a bit for. Then use my jigsaw to cut the rest. Quote Link to comment Share on other sites More sharing options...
avguytx Posted September 17, 2018 Author Share Posted September 17, 2018 The most odd angles are on the ramps on the back side of the cabinet where the woofer fires into the 3" x 13" opening and it routes it to the sides of the cabinet. I built a jig for those cuts to run them through the table saw. That was really the toughest cut, if I had to pic, of all that was done. I don't believe a router would be able to cut that but I could be wrong. The "flat" section of the angle, that's attached to the top and bottom, was about 3" wide, I believe. See highlighted in red. 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.