Jump to content
The Klipsch Audio Community
Sign in to follow this  
tct

Settings

Recommended Posts

Hey, I got the following setup and am looking to tune settings from AccuEQ Room Calibration

 

  • RF-62II for front left and right
  • RC-52II Center
  • R-12SW
  • Onkyo TX-RZ720 receiver

 

Speaker impedance from the receiver settings is currently set to 6 ohms. The only other option is 4 ohms.

 

The receiver crossover is set to: 40Hz for the front, 90Hz for the Center and 120Hz for LPF of LFE.

Share this post


Link to post
Share on other sites

tct,

 

Welcome to the forum.

 

4 hours ago, wuzzzer said:

Ohms at 6.

All crossover points at 80Hz.

Great starting point.  And ending point most of the time.

 

Bill

Share this post


Link to post
Share on other sites

Thanks! I'll set it to that and run the AccuEQ Room Calibration afterwards.

  • Like 1

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

×
×
  • Create New...