Jump to content

LaScala Crossover?


SonicSeeker

Recommended Posts

Are there handles on the sides?  

 

Looks like someone has done a few customizations.  Nor a bad thing but it does make it harder to figure out what you have. 

 

Take a photo of the crossover from the top looking down. Folks here will be able to figure it out from that view.  

Link to comment
Share on other sites

I'm pretty sure it's an AL-3 Split.

 

I see just about everything that I see on the schematic. So, I think whoever originally owned these, contacted Klipsch and bought an upgrade kit. For that specific year, it should have the K-55-V instead of the K-55-M.

 

I can see the two high pass coils, the 5mH ferrite core bobbin in the back left hand corner, the 4mH for the low pass on the right, the tweeter protection (resistor/polyswitch), the electrolytic in the back that's undoubtedly the low pass cap (probably a 140uF), and two of the three 2uF little black box motor runs -- I'm sure the third is lurking back there somewhere. Finally, if you look at the note on the bottom of the schematic, it says, "2 POINT BARRIER STRIP", and "X RED WIRES ARE CUT FOR BI-AMP PURPOSES" -- and those are there too.

 

 

post-30216-0-28620000-1390167789.gif

Link to comment
Share on other sites

  • 3 weeks later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...