NBPK402 Posted December 7, 2023 Author Share Posted December 7, 2023 Here is a side shot..you can just barely see the support going to the front and the piece it is attached to, that is screwed to the horn mouth frame. 1 Quote Link to comment Share on other sites More sharing options...
NBPK402 Posted December 7, 2023 Author Share Posted December 7, 2023 Here is a closeup to part of the temporary stand...the stand is attached to the k402 horn. Quote Link to comment Share on other sites More sharing options...
Delicious2 Posted December 7, 2023 Share Posted December 7, 2023 What are your settings for crossing over the MEH woofs to the F.20s? Any measurements? How does it sound? 1 Quote Link to comment Share on other sites More sharing options...
Filk Posted December 8, 2023 Share Posted December 8, 2023 Awesome build. 1 Quote Link to comment Share on other sites More sharing options...
NBPK402 Posted December 8, 2023 Author Share Posted December 8, 2023 4 hours ago, Delicious2 said: What are your settings for crossing over the MEH woofs to the F.20s? Any measurements? How does it sound? I am playing around with the crossover point still...currently trying 40hz. I am also running a Harmon curve. Sounds good, and def digs deep! I will be doing some mods to the setup and then retuning. 1 Quote Link to comment Share on other sites More sharing options...
NBPK402 Posted December 9, 2023 Author Share Posted December 9, 2023 I also need to learn how to align the phase from one speaker to the next in REW. Quote Link to comment Share on other sites More sharing options...
Delicious2 Posted December 22, 2023 Share Posted December 22, 2023 By this do you mean aligning the drivers within a system, so that the woofers are aligned with the tweeters? Maybe you mean the left speaker with the center speaker and being sure that that pair is in phase and then aligning the right speaker with the center speaker and being sure that that pair is in phase etc.? Quote Link to comment Share on other sites More sharing options...
NBPK402 Posted December 22, 2023 Author Share Posted December 22, 2023 REWhas a feature i found where can run all your speaker individually and the bring up the phase readout or impulse and you can align each speaker phase or impulse to be the same. 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.