Jump to content

Four RP-280FA's - How to connect to reciever?


Lyle Beach
 Share

Recommended Posts

I am setting up a 5.2.4 and I have four RP-280FA's.

 

Two of them will obviously be Front R and L main channels with the Atmos connected to "front presence", and of course my center channel (RP-450C) is connected to "center" 

 

My question is... What do I hook up the other two RP-280FA's to? I know the Atmos part of the tower goes to "rear presence" (on a Yamaha RX-A3080), but what do I plug the other terminals (main part of tower) into? Surround? Or Surround Back?

 

Thanks

Edited by Lyle Beach
Typo
Link to comment
Share on other sites

2 minutes ago, babadono said:

I'm no expert but I think your first set of "surround" speakers should go to the "surround" output. "surround back" would be speakers almost directly behind the listening position.

check out https://www.dolby.com/us/en/guide/dolby-atmos-speaker-setup/7-1-4-setups.html

from the same website.

I agree, if you added two more then use rear surround.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...