MTBANDMUSICINFL Posted August 9, 2019 Share Posted August 9, 2019 Upgraded to Crites sonicaps except I did not replace the resisters. Then, the mid range did not work. Isolated the problem to be in the crossovers. Tweeters work, woofer works. Tested diaphragms in midrange and all - all works. Where should I look specifically in the crossover? Any particular caps that I need to look at? Do I need to replace the resisters? Thanks Quote Link to comment Share on other sites More sharing options...
billybob Posted August 9, 2019 Share Posted August 9, 2019 Not always.. check the wiring between the working X-Over.. etc... Look closely to make certain that no solder ended up where not supposed to. Etc...wire to mid not crossed to driver.. Quote Link to comment Share on other sites More sharing options...
pzannucci Posted August 10, 2019 Share Posted August 10, 2019 Check closely on the solder joints for the midrange. Not much to that circuit but a cap and the autoformer. Doubt the autoformer is messed up, likely the cap that was replaced isn't soldered so it is connected to the board. There is no resistor in the midrange crossover. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.