Pictures of your Tube Amplifiers

[Wardsweb]

Ayon Crossfire III

 

 

[Wardsweb]

Arteforma 2A3

 

 

[Wardsweb]

Chapman 6L6

 

 

[Wardsweb]

DIY 2A3 based on a Loftin-White design

 

 

[Wardsweb]

Antique Sound Labs AQ1006 845DT MKII

 

 

[Wardsweb]

Modded Dynaco Mark III

 

 

[Wardsweb]

rebuilt McIntosh MC240

 

 

[Wardsweb]

Jolida JD-1000RC

 

 

[charlieboy]

Cobalt/M4 Magnequest TFA-2004JR parallel feed output transformers, M4 EXO-003 plate chokes, Magnequest filament chokes, Mundorf and Auricap coupling caps, Cardas posts and jacks, and meters for good measure.

Sofia Electric Princess 300b mesh plates at 2.5v

 

[82 Cornwalls]

@charlieboy

 

By Paul?

[charlieboy]

45 minutes ago, opnly bafld said:

@charlieboy

 

By Paul?

Yes

[charlieboy]

[charlieboy]

813 monoblocks

 

 

 

 

[Chiily]

My self restored Leak ST20, 1963.  Certainly not pipe and slippers.

Edited August 7, 2024 by Chiily

[JohnJ]

Lot of beautiful equipment in these pages. We've had a little cool weather at dark here lately. Varied from the 40s to low 50s, it's 75 outside now but hasn't made it to 70 yet inside with the air getting stirred ten minutes an hour.

Feeling chilly I turned on the amp and it's a couple degrees warmer in here now! Sounds good too realstic voicing and voices plus some Little Feat that does not stink!!

 

[82 Cornwalls]

I bought this very inexpensive JBH 6P14P SEP amplifier with the idea that if it wasn't very good I would build a new amplifier using the chassis. I ordered it without tubes and put in my own NOS tubes. After receiving it and a schematic I made a small modification to the power supply and have been enjoying it.

 

 

[MariuszZ]

SET dualmono SinusAudio 6B4G/6SN7/5C3C

 

[Peacemaker]

10 minutes ago, MariuszZ said:

SET dualmono SinusAudio 6B4G/6SN7/5C3C

 

Gorgeous looking gear! I can imagine it sounds great also. 

[MariuszZ]

Thanks. It meets my expectations 100%. I am also surprised how quiet this amplifier is considering the hum and 99dB/1W/1m speaker efficiency. There is dead silence between songs.

[gigantic]

I'm using a pair of Glow Audio Amp Two that have been recapped with Mundorf M_Cap Evo Oils and Nichicon KZ Muse electrolytics and modded into bridged mono blocks, via XLR to balanced RCA interconnects. They're driving the mids,  along with a quartet of Fosi Audio ZA3 with Burson V7 Vivid and Classic op amps, that are driving the bass and treble in a pair of 3-way horns.