justinsweber Posted November 30, 2020 Share Posted November 30, 2020 Just picked up Dave Harris latest update to his Eliptrac kits, gonna save a ton of time on finishing. Dave says they perform as well as previous models, but he doubled the cuts to reduce finishing. I think Ive sanded more pairs than anyone short of Dave and can tell you, doubling the cuts is magic. The real question is weather to 2way as usual or build another 3way 1 Quote Link to comment Share on other sites More sharing options...
Honeybadger Posted December 1, 2020 Share Posted December 1, 2020 Going to be a lot easier to sand. H.B. Quote Link to comment Share on other sites More sharing options...
OO1 Posted December 1, 2020 Share Posted December 1, 2020 On 11/29/2020 at 8:25 PM, justinsweber said: doubling the cuts is magic. any special technique to sand these ? -------- Quote Link to comment Share on other sites More sharing options...
Honeybadger Posted December 1, 2020 Share Posted December 1, 2020 Not to tough, I fully assemble the horn then sand from the mouth to the throat with 36-40 grit until smooth, then clean up with 80grit. After the horn is sealed, I think I finished with 150 grit. H.B. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.