OO1 Posted June 24, 2021 Share Posted June 24, 2021 on the Xilica XP Series , one can always go back to an older firmware revision or opt for the latest - https://xilica.com/wp-content/uploads/2017/09/XIL003_UserManual_XP.pdf Quote Link to comment Share on other sites More sharing options...
Wrench Posted June 26, 2022 Share Posted June 26, 2022 (edited) Follow these instructions: https://www.youtube.com/watch?v=7qJIWuUOXGA I found the Xilica to network adaptor, cat 5 ethernet, connection worked best for me. Giving me the distance I wanted. Edited June 28, 2022 by Wrench Quote Link to comment Share on other sites More sharing options...
Schu Posted June 26, 2022 Share Posted June 26, 2022 6-19-2021 Quote Link to comment Share on other sites More sharing options...
Emile Posted June 26, 2022 Share Posted June 26, 2022 Yes; old post. But, just in case ... Xilica has an XConsole download AND AN ADDITIONAL USB driver download Quote Link to comment Share on other sites More sharing options...
Dave A Posted June 26, 2022 Share Posted June 26, 2022 I have a Xilica 3060 on my main system and Win 10 works just fine with it as does my Furman power conditioner. You do not need a stand alone power conditioner just for the Xilica. I feed my two amps and the Xilica from the Furman and my setup is dead quiet. I am at the end of a rural electrical co-op's service and everything that effects the power I see and so far no problems. Westcoast gave you good advice on hooking it up. Ask around for someone who is close to you with a Xilica who may be willing to come over and walk you through it. It has been a few years since I set mine up but help from another forum member solved my woes. Quote Link to comment Share on other sites More sharing options...
Dave A Posted June 26, 2022 Share Posted June 26, 2022 39 minutes ago, Schu said: 6-19-2021 HA HA you are right! Respond first and check date later I guess. Quote Link to comment Share on other sites More sharing options...
Schu Posted June 26, 2022 Share Posted June 26, 2022 I had similar issues with windows, you just need to load the drivers and reboot the xilica unit itself. boot sequence should go... computer, xilica, software launch Quote Link to comment Share on other sites More sharing options...
LTusler Posted June 28, 2022 Share Posted June 28, 2022 The 4080 boots on the network with DHCP. Then you use the display on the unit to find the IP address it grabbed. Then you enter that address into the PC app. Or just direct connect it with a USB cable. Quote Link to comment Share on other sites More sharing options...
mark1101 Posted June 29, 2022 Share Posted June 29, 2022 Wow.......didn't even skip a beat. A year is not that long I guess. Quote Link to comment Share on other sites More sharing options...
ClaudeJ1 Posted September 10, 2022 Share Posted September 10, 2022 On 6/26/2022 at 2:43 PM, Schu said: I had similar issues with windows, you just need to load the drivers and reboot the xilica unit itself. boot sequence should go... computer, xilica, software launch Boot sequence is very important for digital electronics. Real life is that way too, for change in performance. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.