Jump to content

WTB: T2A and T4A


Deang

Recommended Posts

On 7/13/2022 at 9:24 AM, Crankysoldermeister said:

Would like to find these in good condition for testing.

 

If the windings are loose on the core, I can't use them.

 

Thanks,

Dean

 

Hey Dean

 

How would one know if the windings are loose? Would one or more of the taps feel like a loose tooth?  Probably a bad analogy but the only one I could come up with.

 

I have a couple of T2A's from E2's I can send you.  The inductance on both is lower than the spec, and they both measure differently from each other.

 

That said, I'd be happy to run some tests on them for you if that helps.

 

Mike

Link to comment
Share on other sites

48 minutes ago, mboxler said:

The inductance on both is lower than the spec, and they both measure differently from each other.

 

Not uncommon.

 

You can tell when you remove them from the board. Give them a good shake, I've had some come right off core. The usual suspects normally come from La Scalas, Belles, and Klipschorns.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...