bobwiley00 Posted January 30 Share Posted January 30 (edited) I recently got a pair of f20 speakers. Hooked them up and the left one sounds fantastic. The right one on the other hand depending on if I hook the speaker wire up to the bottom post it plays the Tweeter. But if I hook the speaker wire up to the top set of posts it plays the 2 mid ranges. These are the first speakers I've had with bi wiring so I'm not exactly sure if I'm doing that right but I don't know what to do here Edited January 30 by bobwiley00 Voice to text errors 1 Quote Link to comment Share on other sites More sharing options...
Marvel Posted January 30 Share Posted January 30 If you are NOT biwiring these, there must be jumpers between the lower and upper terminals. Quote Link to comment Share on other sites More sharing options...
bobwiley00 Posted January 30 Author Share Posted January 30 How is that done? Do i put the Jumpers on the outside terminals or on the board inside? Quote Link to comment Share on other sites More sharing options...
bobwiley00 Posted January 30 Author Share Posted January 30 (edited) Okay I just found a pretty good set of videos that explain bi wiring and whatnot. So I guess after watching a couple of them my question would be am I better off going with bi wiring or with jumpers? I should mention that I live in an apartment and I'm not cranking this system on a regular basis. Edited January 30 by bobwiley00 Voice to text errors Quote Link to comment Share on other sites More sharing options...
billybob Posted January 30 Share Posted January 30 Outside rear of speaker with jumpers, like the rear of the working speaker. Red to red, black to black. ☕ Welcome! @bobwiley00 Quote Link to comment Share on other sites More sharing options...
wuzzzer Posted January 30 Share Posted January 30 Go with jumpers. 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.