Bar 48 additional wired sub output.

[Kevin Haines]

Cannot get any output from the analog sub output of the Bar 48. Verified that is where the problem is. Any software update fixes for that? Or is the port just inoperable?

[Peter P.]

How did you verify that is where the problem is?

 

Help us eliminate possible causes by detailing your troubleshooting steps

and telling us what you've already tried to remedy the problem.

[OO1]

On 7/3/2024 at 12:59 PM, Kevin Haines said:

 . Any software update fixes  

 Step 1 -  do a Factory Reset 

▶️   https://support.klipsch.com/hc/en-us/articles/360044128312-Bar-48-Factory-Reset

Press and hold the Power and Source Select buttons simultaneously for a full 10 seconds.
Once complete, you will see the source LED light on the front of the bar turn Orange with three white LED's on top of it

VIP -Performing a factory reset will clear all user paired devices.  They will need to be re-paired after the reset is complete

 

Step 2 -Update the Firmware  

 ▶️   https://support.klipsch.com/hc/en-us/articles/360043401632-Bar-48-Firmware-V30-V83a-Update-Instructions

 

[Kevin Haines]

Factory reset did not work.

Firmware update complete, but no second sub analog out.

[OO1]

6 hours ago, Kevin Haines said:

 no second sub analog out.

 

the 2nd sub must only be connected to the SUB OUT jack   , if you're using a wireless sub , plug the wireless transmitter into the "SUB OUT"   

 -if all fails, the unit has a hardware defect  .

https://support.klipsch.com/hc/en-us/articles/360046083192-Bar-48-Adding-a-Second-Subwoofer