popeyechiken Posted December 23, 2001 Share Posted December 23, 2001 I was just wondering if the 4.1s work with the RB-1 stands. I got the stands and I can't seem to get the speakers on them! Cuz all of them have desk stands already. haha Quote Link to comment Share on other sites More sharing options...
justin_tx_16 Posted December 23, 2001 Share Posted December 23, 2001 yes, the RB-1's work with any promedia speaker but you must take off the current speaker stand and also read the directions... Lol! most peopl efind out that after reading the instructions a few times that it makes sense and they get them hooked up pretty easily ------------------ -justin I am an amateur, if it is professional; ProMedia help you want email Amy or call her @ 1-888-554-5665 Klipsch Home Audio help you want, email support@klipsch.com or call @ 1-800-KLIPSCH RA# Fax Number=317-860-9140 / Parts Department Fax Number=317-860-9150 Quote Link to comment Share on other sites More sharing options...
Paragon Posted December 23, 2001 Share Posted December 23, 2001 ok.. lets try this again.. lost the first instructions I was writing.. OK.. first.. take the screw out of the bottom of the sat that is holding the stand and then slide the stand out - the screw may be on tight as well as the stand - make sure you use a large philips head screwdriver that fits tightle in the screw so you do not strip the head - you will need this screw later so set it aside. The above image shows how the correct bracket should be places and screwed on with a flathead screw included with the RB-1 stands. The other hole is where the sat is screwed on bt sliding the sat on and using the screw from the old stand Hope this helps.. any questions just ask. This message has been edited by Paragon on 12-23-2001 at 07:25 PM Quote Link to comment Share on other sites More sharing options...
justin_tx_16 Posted December 23, 2001 Share Posted December 23, 2001 man am i glad youre back paragon! ------------------ -justin I am an amateur, if it is professional; ProMedia help you want email Amy or call her @ 1-888-554-5665 Klipsch Home Audio help you want, email support@klipsch.com or call @ 1-800-KLIPSCH RA# Fax Number=317-860-9140 / Parts Department Fax Number=317-860-9150 Quote Link to comment Share on other sites More sharing options...
Paragon Posted December 24, 2001 Share Posted December 24, 2001 Thanks.. good to be back. Quote Link to comment Share on other sites More sharing options...
bertdimson Posted October 18, 2009 Share Posted October 18, 2009 Can you please upload the image again showing how the correct bracket should be places and screwed on with a flathead screw included with the RB-1 stands. I recently got my SAT2 speaker stand and there is no image on the instruction manual showing how it works on promedia. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.