Jump to content

Wrench722

Regulars
  • Posts

    724
  • Joined

  • Last visited

About Wrench722

  • Birthday 07/22/1960

Profile Information

  • Gender
    Male
  • Location
    Spring TX
  • Interests
    SOUND!
    SCUBA!
    WOOD!
  • My System
    Livingroom
    1-McIntosh MX122
    1-McIntosh MC8207
    1-McIntosh MC152
    2-McIntosh XRT1K
    5-McIntosh XCS200
    2-McIntosh LCR80
    2-JL Audio F212V2 
    1-77” Sony OLED AE-1

    BEDROOM #1:
    1-Yamaha RX-V2400
    2-Heresy
    2-RS-25
    1-42" LED Samsung

Recent Profile Visitors

4307 profile views

Wrench722's Achievements

Forum Veteran

Forum Veteran (4/9)

16

Reputation

  1. YEP! Frankenstein is AMAZING on them! I wish I could keep them but having to down size.
  2. These are built by a master craftsman out of walnut and birch from Houston Hardwoods. The woofers are B & K Enterprises (Crites Speakers) CW1526C 15” Cast Frame. Midrange is Altec 511B horns with B & K Enterprises (Crites Speakers) Atlas PD-5VH Alnico Midrange Driver. Tweeters are JBL 2404H Bi-Radial Horn Baby Cheek Tweeter Speaker. Crossovers are ALK Engineering ES400 / ES5800 Extreme-slope Woofer / Squawker Networks. I am downsizing and I must sell them. I have put a link to a Dropbox with a ton of pictures of the build process. $6000. OBO. [Moderator edit: You can't call them a something that is a registered trademark of Klipsch if they are homebrew. I changed the title] https://www.dropbox.com/sh/7k44mf32j7dwwhk/AACKmrnYtHbmiuqetZUAq5Fja?dl=0
  3. I am installing a set of rear speaker and I have to run the speaker wire through the attic along side 10 or 15 AC wires. The wire are HVAC, Dryer, Water Heater and a few wall out lets and lights. Will I get interference from the AC wire into the speakers?
  4. I have been a Klipsch junkie for over forty five years and I wanted to hear my Klipsch with the best amps possible. I noticed that Paul Klipsch used McIntosh amps to power his speakers. So I went out and purchased McIntosh amps to power my Klipsch. Man! What a great sound! I found a great deal on a McIntosh XCS200 center channel speaker and man that thing is the best sounding speaker I have ever heard!! The clarity is just unreal compared the the Klipsckorns I have as my L/R. What is McIntosh doing to there speakers that Klipsch is not? I am now in the market for new L/R front speakers....
  5. What are we talking with shipping to 77388?
  6. I ran Yamaha with my Klipsch for years and it had a really great sound until I went to McIntosh. McIntosh is a game changer!
  7. I guess no one uses a tuner any more????????
  8. I have just purchased a McIntosh MC8702 and MX121 and looking for a low cost am fm tuner that will switch on and off with the systems 12 volt trigger. I would like something that has a remote to it.
  9. I did both RWS15's Subs through them and they did a great job!
  10. I am going to be in the Hope on 3/10/17 and was wondering if the museum would be open and if I could get a walk through of the factory floor?
  11. I have two RSW-15's and one has stopped working. I saw ad for Edwards Electronics that said they would replace known as bad quality parts, some electrolytic capacitors also will be replaced, for $150.00 each. Does anybody have any feed back on Edwards Electronics before I dish out $150.00 plus shipping?
×
×
  • Create New...