Jump to content

mathewvarghese2001

Members
  • Posts

    7
  • Joined

  • Last visited

mathewvarghese2001's Achievements

Newbie

Newbie (1/9)

0

Reputation

  1. Hi All, I live by the sea side where humidity levels are pretty high. It is common for electronic items to corrode due to the salt content in the air. My Klipsch speakers are affected by fungus due to this. I have attached a picture for your kind reference. I am looking for advice on how I should proceed with cleaning up the fungus from the speaker cones and areas around it without damaging the speaker cones. Many Thanks for your kind guidance, Matt
  2. Thanks All. Based on your guidance, I realized that the promotion is only a US one and hence I am unable to see the "Add to Cart" option on my browser as I am based outside of USA. Thanks for your time and support, Matt
  3. Hi All, When I visit Klipsch.com, I see a promotional message "Deal of the Century 50% off promotion on P-37F (ends July 31st)" with a SHOP NOW icon. However, on clicking SHOP NOW it just takes me to the product specs. I am looking to buy the P-37F online if the above promotion is still valid. Appreciate knowing if the promotion is valid and if yes, how could I get the 50% off from the online retailers ? Thanks, Matt
  4. Hi Loudogp250, Bill & Avguytx, Many thanks for the welcome. Appreciate it. To answer loudogp250's question, I have not "bi-amped" the speakers and the binding posts are still interconnecting the terminals. I will follow the directions to bi-amp over the weekend and let you all know of the difference. To Bill's question on room size, the room dimensions in meters are as follows : (wall to wall length =8.5 meters, wall to wall width=4meters & floor-to-ceiling height = 3.2 meters). I am located in Singapore. BTW, do you have any recommendation for an active/passive Klipsch SubWoofer for this setup ? My existing JBL Sub which was a few years old is dead. Many Thanks, Matt
  5. Hi Experts, I recently upgraded my receiver to an Onkyo TX-RZ900 which is no match for my existing Klipsch WF-35 fronts. I need to really increase the volume on my receiver to hear the details in the musical track.. Here are the key specs of the receiver : GENERAL SPECIFICATIONS Power Output: 200 W/Ch (6 Ohms, 1 kHz, 1% THD, 1 Channel Driven, IEC); 235 W/Ch (6 Ohms, 1 kHz, 1 Channel Driven, JEITA) Frequency Response: 5 Hz–100 kHz/+1 dB, -3 dB (Direct Mode) Question : Can you recommend me the best and next-to-best floor standing speakers from the Klipsch that can match the specs of the Onkyo receiver while allowing me to hear music at lower volumes with all the details.. Many Thanks in advance, Matt
  6. Thanks a ton to both of you for your valuable replies. Appreciate it.
  7. Hi, I am planning to gift my brother an R-20B SoundBar. However he lives in Asia where they use 220volts AC power. Question : Does the R-20B SOudbar/Subwoofer suport an input of 220volts ac/60Hz ? Thanks, Matt
×
×
  • Create New...