Hi Everyone,
My amp was going out for a while in that the sats would turn off after about 20min of use. Now they completely went out...I read up about the mosfet replacement, and decided to give it a try.
I replaced the satellite side mosfets on the BASH switch board (part NTE2395), and fired it up. It works at high volumes, but with a ton of static. I discovered on accident that if I short out ANY 2 pins on either MOSFET, everything works 100%. I'm tempted to just solder two of the legs together, pack it back up and be fine....however I'm thinking that by shorting 2 of the legs on the mosfet, it is being completely bypassed and not regulating voltage.
If anyone has any suggestions i'd greatly appreciate it!
Thanks
Daniel