[RW-5802 II Pop]

Okay, thanks for the reply's!

 

Would anyone know if/how I can get a replacement SecureFit bracket for 1 of my PRO-250-RPW speakers?

 

[RW-5802 II Pop]

I changed the power setting on the AMP to "On" and that resolved it.

No more pop, it must have been going to sleep and when it came back on that was the pop.

 

I'll have to look at the specs for the amp but the Denon guide just says as long as it's 120V I should be able to use it.

I can move it to the Panamax, I have plenty of open outlets.

 

[RW-5802 II Pop]

Here are the 3 options for Power Mode.

 

5. Power Mode Selection
The Power Mode switch has three settings – “Trigger”, “Auto”
and“On”. In the “Trigger” position, leave the Master Power switch
in the “On” position and set the Power Mode switch to the
“Trigger” position, then the amplifier will automatically turn itself
on and off when 5-30 volts DC is detected or removed from the
rear panel 1/8" Trigger jack. Tip is positive, ring is negative.
There is no delay when using the Trigger function. In the “Auto”
position, leave the Master Power switch in the “On” position and
set the Power Mode switch to the “Auto” position, then the
amplifier will automatically turn itself on and off when an audio
signal is detected or removed from the rear low or high level
inputs. There is a 2 second On delay and a 15 minute Off delay
when using the Auto Power function. In the “On” position, the
Master Power switch turns the amplifier on or off. Set the Master
Power switch to the “On” position and set the Power Mode

switch to the “On” position, then the amplifier will turn itself on
and off with the Master Power switch.

[RW-5802 II Pop]

I have the Receiver plugged into a PANAMAX M5400-PM and the AMP plugged into the Receiver.

After reading the manual on the Power mode, I feel that's what it could be.  I will change that and see what happens.

Thanks for your responses! 

 

Here is a pic from the manual of the amp

 

[RW-5802 II Pop]

Yes, definitely coming from the sub.

 

I'm gonna go through the Denon Sub settings to verify those are correct. 

I moved and everything was unplugged for a good week.

[RW-5802 II Pop]

Hello everyone, 

 

I just installed the RW-5802 II along with the recommend RSA-500 Amp.  I have the Lowpass set all the way down to 40 and the Level set 1/2 way.  Bass sounds good at that setting.

The sub is paired with the PRO-250RPW for the 3 fonts and a pair of PRO-180RPC for the surrounds.  My receiver is a Denon AVR-5800.

In reading the manual I see that there is an Equalizer Selection and should be at 1 but I'm not sure what it is currently at (I'll check on that).  Power mode is set to Auto.

I am using the LFE input for this connection to my Denon.

 

My issue is that every once in a while I hear a pop from the sub.  Not sure if I need to change a  setting or maybe it is the power setting?

 

 

[New Install]

Hello, I have purchased a new construction home and trying to figure out speaker placement. 

I am looking at purchasing the PRO-180RPW for the Front Left & Right and the PRO-250RPW for the Center.

Should I go with the PRO-250RPW for all 3?

The other question is on the Center channel orientation.  Looking at the specs for the 250 it will not fit horizontally between the studs.

I could install vertically but then what does that do the heights of the TV in order to mount it that way?