psc33

My crossover goes to 200 should i set it to that or the 120 Thanks again for your help

Hi doug, I should set the subwoofer setting to no even though i have one?

here are some of the options i am lost on D.Range (SP-DR & HP-DR) LFE LEVEL (SP-LFE & HP-LFE) CENTER GEQ A DELAY TC BYPASS(SET TO AUTO NOW) PARAM INI MULTI ZONE- SPB FRONT Again any info would be helpful Thanks

Hi guys thanks for the info, Doug do i do those connections only if i dont have the crossover or should I do it even if i have that?(Then connect your main speaker outputs from your Yammy to the high-level inputs on the Sub10. Connect the front Quintets to the high-level outputs on the Sub10. Set the Sub10 crossover to somewhere around 80hz.) Also there are a few other settings that i have no idea what they are. I will write them down and get back to you maybe you could help with that also. Thanks again PS Was this a good deal or did i get taken?

I purchased A Quintet III sytem with a Sub-10 subwoofer and a Yamaha Htr-5840 receiver , Any suggestions with the settings? Also how would people rate this system, Got it all for just under $1000, Is this a good deal? It sounded unbelivable at the store (best buy- had it hooked up on display, not in a special room) Hooked it up at my house and doesnt seem to compare to what I heard at the store went back and spoke with the salesman and he said it just needed to be tweaked, Hence the first above question. Im a first time Klipch buyer and hope I made the right choice. Any help would be greatly appreciated!! Thanks